'65 Dodge Coronet Engine Harness

VANDAN · Jan 29, 2022

I'm looking ahead to my '65 Coronet build, and pre-planning whatever I can. I'll be pulling the slant 6, and using a Gen II Hemi, with most likely a Street Hemi 4x2 intake. Will an engine harness for a '65 BB, 383/426 wedge engine fit properly on it ? I'm thinking it should lay pretty close to where it will fit/work properly. Any, and all feedback welcome, Thanks...

Fran Blacker · Jan 29, 2022

Don't know this is an option.
http://www.kramerauto.com/proddetail.asp?prod=M8-EL-001

VANDAN · Jan 29, 2022

Fran Blacker said:
Don't know this is an option.
http://www.kramerauto.com/proddetail.asp?prod=M8-EL-001

Thanks Fran. I got one like that for my '63, MW, and they route those along the pass fender well. I'm thinking the harness that comes off the firewall, along the valve cover - intake routing would work, like a street wedge ?

Big bill · Jan 29, 2022

I used a /6 harness on my 65 Hemi belvedere AWB car , I did add to it with dist and voltage reg upgrades and such tack .

Dodge33 · Jan 29, 2022

VanDan, I need to look for it, it is in with some other
stuff... the engine harness was removed from a factory 65
Dodge Coronet w/a 361 727 trans. I will try to check it out tomorrow. When we removed it from the car, I'm pretty sure there were not any cut or bad terminals on it.

'65 Dodge Coronet Engine Harness

VANDAN

FBBO Gold Member

Fran Blacker

FBBO Gold Member

VANDAN

FBBO Gold Member

Big bill

FBBO Gold Member

Dodge33

Well-Known Member

Similar threads