• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Edelbrock 4150 carb

I saw a dyno test of that carb comparing it to a couple others. I believe it was on engine masters.
 
I have never run one but it has one disadvantage - it is a half inch taller than a Holley.
If you are not tight for space I looks quite good.
 
They announced it at SEMA and PRI last year and still don't have any pricing on it yet. I think they are sniffing the market for the demand for a 4 circuit cast aluminum carb. Doesn't cost a lot to make a few hundred prototypes when you own a foundry
 
IMO.....IF you want a Holley looking carb, why not just buy a Holley carb? There are Holley models that offer the same adjustable/tuning functions as these Edelbrock appear to offer. Who manufacturers these new Edelbrock carbs? Is it Edelbrock or Weber or ?? Where can one purchase the tuning parts ( jets, air bleeds, power valves, power valve channel restrictions, gaskets, accelerator pump diaphragms, etc) and at what cost and availablity. Just my opinion of course....
BOB RENTON
 
It is about 30 yrs too late....
Will not look right sitting on an electric motor.....
 
Auto Transport Service
Back
Top