Separate names with a comma.
Make them. Mike
Is this bar spring steel or could it be bent to spread the width and provide more clearance? Mike
Chinese rubber is NOT a good quality like OEM. Just install a restraint. Mike
I have been using antisieze for this purpose for at least 30 years with no bad result. Mike
I would use as is. A little silicone grease or antisieze could be used as lubricant on the ways. Mike
I have never heard of any garage telling customers to return for retorquing and it's not in the service manual. It won't hurt anything to do so. Mike
Can we assume the rear drums are properly adjusted? Mike
The bar I added to my 65 Coronet had to be mounted with the dip facing the ground. Mike
Hi Ron, Right under the master cylinder works, if you don't mind drilling a hole in the floor, I have one in my 66 with just the knob above the...
No, and Yes. Mike
On the ends. Mike
Torsion bars are side specific and marked as such. A switch would probably result in a broken T-bar. Mike
It should be fine. Why do you think DOT 5 is bad? Mike
Dot 5, I believe, is silicone based so it will not mix with 3 or 4 but, it is not hygroscopic. Ideal for toys. Mike
YEP! Mike
My lower control arm bushings looked OK until I pulled the arms out! Wow, the bushings were trashed. Mike
Sure. The master cylinder doesn't know where your placed it. The brake lights in most of our cars are actuated by a mechanical switch near the...
I can't answer that but, it would be easy to turn one on a lathe out of plastic. Mike
Your bits are too dull? I don't see why why that would not be a workable solution. You may be able to shorten the housing tube at the same time...
I can't say for sure but, it only makes sense. Extra parts cost the factories more. Mike
