Separate names with a comma.
Cams can be swapped from B to RB.
I can guarantee that your 18 spline 4 speed didn’t come with Mobil 1 from the factory not in the owners manual suggesting it be used.
My buddy rebuilds all my 4 speeds, they all get Pennzoil Synchromesh.
Then I’d use what was posted.
Does it have a sure grip? If so, clutch or cone?
Are the bleeder screws at the “top”? If not, swap sides or use a block of wood and have the calipers pointed so the bleeder screw is at the top.
If the OP is worried, that would alleviate any worry.
50/50, choose wisely.
Groove the cam, problem solved.
Your bearing clearance’s should dictate what oil on the hot side you should run and the area of the country that you live in should dictate what...
Check all the bolts and front/rear spring hangers.
Does the yoke on the rear end move up/down?
Not sure what size (OD) of the yoke is supposed to be, but you could look that up and measure yours to see if there’s any difference.
How much up/down side/side play does the yoke have inside the tail shaft?
It shouldn’t move a 1/4” like the OP stated. Also, poly will not move nearly as much and allows the power to be put to ground instead of being...
Get 2 5/8 bolts that are 5 inches long, cut the heads off, cutoff wheel works for making a slot for a flat head screwdriver. Install the bolts...
No! It shouldn’t move 1 bit. Get a poly mount for it.