Separate names with a comma.
Found mine on E bay. 400 for the block stock bore. Plus, shipping. Troy Michigan. Too Fl. Went 20 over to clean it up. Built an A/C car and rather...
Thanks.
No power valve on secondary.
Ok here it is. Motor was rebuilt and heads done. Thumper cam like the purple cam. Running 650 Holley single pumper. Running 80 Jet's and metering...
So been driving my car for a while now. It has started a little run on when shutting off the car. like a bur when turning off the car. Have...
Doc. Diff is who I got mine from. But you still need the plug in the differential. That spacer that keep's the axel's from going too far in.
Used Green Bearing's on my 8 and 3/4 1500 miles so far no problem's. No doughnuts. Just burn out's. LOL. Road runner too big of a car to do drifting.
That seal block need's to have gray Permatex put in the corner's and on the sides where it goes together. That is one of the spot's where it will...
Looks like everyone covered all the bases. The rear main seal is the worst problem with most motors. Take a weekend and put a new seal in and...
There is no divider on my Holley intake it is open inside. You can see each tube that feed's the different cylinders. Middel cylinders have tan...
Have a 383 in the runner. Mid high rise Holley intake. When reading the plug's notice that the 3-5 cylinders are running about right as well as...
Thanks for that info. That is what I needed before rebuilding the 489 to put into the car. Hate to spend money then find out I can't use the pig....
Got a hole new oil pump from Summit. No worries now. Not that expensive.
Just to kick this around. I have a 489 rear end and have the open 741 pig in the car now. Will my axles work with the 489 or are the splines...
Thanks for correcting me. I have the 741 and just knew it did not have the same U joint as the 489. The numbers should be on the pig itself or an...
Clutch type is hard to find. Cone types are much easier to get. Doctor diff. Sell rebuilt one's. If he has them. If you switch out from the 741...
Have you guy's tried adjusting the third gear band's. Or checked the portioning valve. Their are kit's to rebuild those 727 trans. An old guy...
Just to say it look's a little rich on the fuel mixture. Too much black on the plug. Should be more a tan color. Just my two cent's.
Man it really got hot. Do you think you where too lean on that hole. When pulling down my 383 noticed that one piston hole had a lot more heat in...
Are you running Nitrous. Last time I saw that is when we where trying to run the Nitrous combo and all we had was button and a squiter. Held the...
