Separate names with a comma.
Still looking for Plymouth door panel emblems for 1965 Belvedere II
Looking for the Plymouth front door panel emblem for a 1965 Belvedere II.
Need choke pull-off connecting rod to fit Carter carb 3860S. Thanks
Thanks Joe. Got clip from Mike
Looking for just 1 clip that holds the stainless molding above gauge cluster on a '65 Belvedere or Satellite. Also, 6 clips that hold stainless...
I will also take a switch that I can use for parts. Thanks
Looking for a couple of plastic buttons for a 65 Belvedere heater vacuum switch. I don't need the push button that has off, heat, etc. or the rod...
Three different transmission were used in 65. The 904 was used with the 273, small block 727 used with 318, and big block 727 used with big block...
Looking for gray 21 tooth speedometer gear for 1965 727 transmission, part #2204360. Thanks
Looking for the small sliding clips that attach the panels that fits between taillights of a 1965 Belvedere II. These are not the six studs that...
Looking for 62/65 B body sway bar bracket. The bracket that I need attaches to the sway bar and has a threaded stud that holds a circular bushing....
Yes, I got picture, but really need lever similar to the one in Randra's picture that is on the end of the kick down rod. The lever was used from...
That is not what I need. The 66 uses two kick down rods. Your picture shows just the lower rod. The 62-65 uses a single rod. This changes the...
Not sure. Maybe someone can chime in on information. Mine is column shift with cables. I would think that since the kick down linkage connects...
I'm looking for the lever that fits on the transmission not the kick down rod.
I don't know if it has a part number on it, but the part number is 2264744. Thanks
Looking for kick down lever for 65 b body that is fasten on the 727 transmission. Different than 904. All V8 engines except 273 use the same...
I do have the 65 big block 727 transmission.
Looking for slip yoke driveshaft for 1965 Belvedere with big block 727 transmission. Should be about 53 1/2" long. Thanks
Picture of hub I need:[ATTACH]