Separate names with a comma.
I think your going about it in reverse as many cams will work with that profile. Xe275HL and XE285HL I believe recommend those springs. Pick your...
I'm not sure but I'm guessing they are a lot older. I can't remember when they went away from Sig Erson to Erson. The font is definitely 70s looking.
What year is your catalog? Curious to what era these might be.
Thanks @wagonman! Would a solid.have a snap ring???? I guess the "M" is for mechanical?
I found these NOS Erson Hydraulic lifters @ the swap meet but cant find this number anywhere. They look like they may have come out of the 70s or...
Im not a pro. You can't do anything until you have the valves installed. Once they are seated ( and lapped in) you will need to place the...
Cant do anything unless you have one of these.[ATTACH]
It has to be counter clockwise and may take a bit for it to pick up & get all the air out.. I recommend using a 1/2 drill as well.
I know you are familiar with Mopars but when you went to prime the pump you did have the drill in reverse didn't you?
Thanks for the info on the side clearance. I have some shims as well as a new set of spacers and will try the .015!
The billet steel spacers, I have RPM heads and they actually had nice alignment on the valve stem to my untrained eyes. I would listen to Mr...
I have the same setup, I used a bench top belt sander to take off the excess material and got it close the used some finer grits to clean up the...
The FSM recommends and shows how to check clearances of the rotor and top plate. Im suspicious of 6psi even with the gasket installed wrong. I...
Take a gamble on saving g $5-600 vs $3500+ in rebuilding a motor...odds are not in your favor!
Would the Comp XE/HL series cam lend themselves to a tick with proper preload? TY!
Which valvetrain components do you have? Im having the same issue almost like a lifter tick. I have the Comp ProMag rockers which Comp says...
Take the belt off and start it, agree that it sounds like a rotational type noise.
Look in your exhaust for the missing piece, header /collector/ manifold. Definitley need to check your piston to valve clearance before...
KB requires .0065 x bore w/ minimum .026 for top ring and .004 for second ring for NA gap. http://enginepro.com/downloads/kb_installation.pdf...
@andyf
