Search results for query: *

I'm going to say there for a different model, and TTI is the only way to go with mopar headers imo

The bubble is is a common issue with mopars of that Era, corrosion is lifting the lead seam.grab a torch and melt the led off , better then grinding and getting lead in the air . The yellow box looks like the lead was worked into the window chanel. Red, melt the lead and fab a small patch ,or...

I would remove the drive train to alow access to the fire wall pinch welds ,also sometimes the pan needs to be jacked up to meet the rear pan and the drive shaft is usually in the way, The best way to set the car up is on stands. However make sure the stands are level with each other and not...

Go leafs go!

Sounds way to complicated. Degreas engine bay, strip paint with 3m 07470 Clean & Strip Discs and wire wheel, Prep steel to epoxy manufacturers recommendations (usually 80 grit) and shoot some epoxy. Also if you don't have any body work to do in the engine bay, let the epoxy flash off and paint...

This is what I use, they work well if there sized correctly and if you're clean shaved https://www.3mcanada.ca/3M/en_CA/p/d/v000152403/

Who ever installed the lock cylinder/ emblem after the car was painted ,probably needed to file the paint build up around the holes to make the parts fit . Allowing moisture to be absorbed by the primer / filler that was left unpainted.

I'm having the same problem with a build I'm doing, luckily I have 3 other chargers to compare measurements to. I'm currently putting a few measurements pages together to have a more complete reference for other builds. I to was surprised at how little information there is from the factory...

Avro arrow

National Mo-Parts – Est. 1987 they will probably have one off an old harness, or be able to source one

I have used both amd and goodmark rails in the last year, both have length issues. mostly due to the flanges at the torsion crossmember being bent sloppy, also have found some the "k" frame mounting plates to be off set of the rail center lines .causing the measurements to be off . If you...

Did a little surgery

Sorry it's not my car, just the look I was going for my build

American Racing AR215 wheels grace all four corners, 20 x 8 in front and 20 x 10 in the rear, wearing 235/35/20 and 275/40/20 tyres respectively. https://garagehotrods.com/2020/11/12/luke-arenas-69-charger-r-t-from-australia/

Dakota digital makes a good kit thats easy to install

Torq thrust d

I built this one a few years back

I love the build ,grate stuff. But the pipe reinforcement is concerning. If the car ever gets hit, pipes like that have been known to impale people.