Search results for query: *

As far as I know, just the A-833, whatever the 3-speed manual is and anything produced by Brewers Performance. The A-833 is very strong

No. It does go in the water pump housing, but it screws in the on the passenger side "back into" the housing, not "down into" the housing

Lean Burn elimination is common. The whole system, distributor, etc removed & replaced with a ‘72-style (or aftermarket) ignition

Others here know more….but if you have a driveshaft that’s the correct length and attaches that “trunion” (?) tail shaft, I think you’re in good shape….maybe the shifter needs changing? Maybe not? You need pedals, a tang (?) to weld on the frame to connect to the z-bar (linkage), make sure your...

Dr diff is the favorite here, but moser or strange axles are good too. I’m not sure about Yukon

Why are you pulling the motor? Not needed to replace the oil pan (fyi)

You will fail California emissions (if required) without a PCV valve

I added a mechanical temp gauge to the hole on top of the water pump housing with the "square drive" plug in it (big block). Your sensor could go there if you've got a big block

3psi sounds low for fuel pressure

I’m running Isky rocker and a hydraulic cam. Follow the adjustment order carefully and make sure you stay with cylinder #1 at TDC. I loosen the nut & put the pushrod in. Then, I twirl the pushrod with my left hand and turn the adjustment screw with my right hand back and forth until I hit the...

Yes, use the hole where the 3/8” square hole is. You’ll probably need to heat the area with a torch and use a breaker bar adapted down to 3/8” to remove the plug. You will need a brass adapter & it’s included with many temperature gauge kits

Well, all 383’s will be neutral balanced & a forged crankshaft 440 with small rods (‘66-‘69) will be neutral balanced also. However, “big rod” 440’s (‘70-‘73) and cast crank 440’s (‘74-‘78) will be externally balanced

Good question….surprise answer. In general, your engine will run better and more efficiently with quite a bit more initial timing advance….maybe 10-15 degrees (guess), but limit your total advance to 34-36 degrees to prevent spark knock. Since you only have a few degrees initial advance AND...

Yes - your question is confusing

There is a good point here.....trying some sealer is cheap/easy to try. If I had to do it a 2nd time...mill the intake

What is happening is that you're sucking some oil up out of the "valley" area and into the intake runners. The valley's oil isn't "under pressure", so maybe you're not burning enough to notice. If you think about it, the leak must be on the front or back (maybe both sides?) of the valley pan...

You are correct

You need the rods, pistons, rings, harmonic balance and possibly flywheel all balanced at the same time

Soak that sucker in Blaster for a few days and see if it frees up

Date is on driver’s side of block…BIG numbers, just look. All 440 cranks are forged ‘73 & older. No way to know if it’s drilled unless it’s bolted to a manual transmission. Six packs bolt to any 440