Search results for query: *

Yes, they are listed, in clear or tinted. Thanks! Mike

Should my glass installer be having trouble locating a new clear windshield for my car? Mike

Is it hard to source nowadays? Mike

More: I fabbed a cover plate for the air intake and used bulk head heater hose fittings. The A/C hoses run through the plenum grommeted at both ends. I ran all the front wiring through the plate also. Mike

My 65 Belvedere installation: Vintage Air, I went with the smaller unit as I have greatly enlarged the tunnel. The water valve is attached to the USCT inner fender brace I installed. Mike

Back in the day I had L 60s on 15" rims with room for more on my 63 Savoy. Mike

I have the OEM coupler off my 65 Belvedere and the body looks good if that would help? I needed the shaft pin but, bought a new pin instead as I have R&P steering now with universal joints. Mike

For the side trim you may like a paint pen. Mike

DWV has reported using electrical shrink tubing with success. Buy the type with glue inside. Mike

The mount has to be moved to the rear into the transmission crossmember or a new assembly can be fabricated. I went with a new unit for my car. The tunnel may need some "massaging" but, no I can't tell you if it would be necessary. I moved further rearward so I built a new, larger transmission...

You may be happier with a 66 K member and modfied transmission cross member. It will gain about 1 3/4" more front end clearance. Mike

Looks good. As soon as I can I will check it out and report back. Thanks! Mike

Too big. Mike

Too small. Mike

Too small. Mike

I just found these in my parts stash. They came off my 65 Belvedere and I blasted and painted them, probably back in 2010. I have forgotten their use. Look like shims to me and located somewhere where they got real rusty! Thanks! Mike

Since I have a trunk mounted fuel cell I mounted a cooler in the OEM tank space. It has a thermostat controlled fan. Mike

I had to look at my 65 today and I used distributer boots as elbows as I thought it would help condensate flow but, I don't think the factory used anything at all. Mike

I determined that the top stand-offs are the shorter pair. Thanks fellas. Mike

It has been too many years since I tore my car apart and I need help with the bezel mounting hard ware. What length plastic stand offs go where in the fender recess? Mike