Search results

So far once I got use to it I like it. Many thanks for the hard work.

Thanks

Being blocked here?

OK, tore her down today and found I must have drilled all three oil passages in that number four cam bearing. I took a fine piece of wire and probed all oil holes and found none blocked, block, crank and cam included. So it looks like since I didn't turn the rotating parts (cam shaft four...

I did that brush thing after the block was cleaned, but didn't post cam bearings.

Pretty informative John, thanks. My cam is a new Jeggs cam, ground for this low compression engine per their engine/cam tech. Oil pump was NOS recommended for all big blocks in the sixties if I recall. It was the first thing I took apart fully and found no debris inside, relief valve nice and...

I did, thanks for your input.