Unless you MUST have the Centerline lug nuts, look at Cragar lug nuts or similar ones at parts stores. Otherwise, check e-bay and keep looking...
Thanks everyone! I think BeepBeepRR found one for me on ebay. I appreciate everyone's help!
Thank you! Yep, without measuring it, it sure looks like my broken switch. So it seems like the '66+ plus A-bodies (& probably C-bodies too)...
I looked again and couldn't find those. I did find this NOS one for $20 from a late 50's/early 60's Mopar. It would work if the diameter of the...
Thanks Dave, it sure "looks" like the same switch in your A-body. In an online search, it "looks" like only the E-body ones are different (some...
Oddly enough, I didn't find one on Ebay & didn't see a reproduction either online. I don't think this part is very rare or wears out too...
I think I may have broken my trunk light switch (70 Roadrunner). It screws into a little tab on the inside lip of the trunk & has a little "L"...
Exactement! Vous parlez francais tres bien aussi
Allo Sylvain, je pense que il y a moins trois ou quatre ici sur FBBO, mais si vous etes en France, je pense que une nouveau est le plus bon....et...
That is A LOT of cam for a street car. The 292/509 cam is really on the ragged edge in my opinion, especially with power brakes.
I've also seen a couple cars that just welded up a 2nd set of spring seats onto an A-body 8-3/4"....but those are a little tough to find.
Craigslist?
"Z-bar" is just slang for....hmmm, I guess you'd call it a "clutch linkage bar". It's a tube that goes between a stud on the bellhousing & a stud...
fyi - also need bellhousing transmission trans linkage shifter linkage shifter tunnel "hump" Z-bar possibly weld z-bar bracket on frame Z-bar...
I will throw out an idea.... why not find a 8-3/4" rear end? With that stall converter you mention in another post, it sounds like you want to go...
Any 361, 383 or 400 intake will fit & they made a lot of 383 4-barrel motors. Any year will work. Get a "square bore" (all carb holes the same...
One little tip I might throw out if you end up using aftermarket parts..... when I was putting a hemi/6-pack pan & pickup on my motor for street...
Just thinking outside of the box a little bit....why not put one system on a wide-open-throttle switch & the second system on a button? That way...
Separate names with a comma.
