Separate names with a comma.
Should twist-off counterclockwise
A mechanic took them off so I just have this number
Yes 11 x 3
Took the slappers off
Sounds like a front end Alignment is in order
Yeah did my master cylinder wouldn't it be nice if the nuts went on the outside of the firewall!
What shape are your Flex lines in? That would cause your brakes to lock up.
I had the same problem as you when getting my car aligned the owner just pulled out a couple of two-by-fours to use as a helper to get it onto the...
a little late to this post, but here is a link on how i pulled mine out. very easy....
i bench bled mine as well. put an old blanket as Moparsmitty said, and went one step farther with painters plastic. i had to configure a...
looks like your rotor failed. is there a chunk out of the inside of the rotor?[ATTACH]
don't rule out your strut rod. i had noise coming from my front end after new build. come to find out, strut rod nut not torqued down.
i had same problem when replacing my master cylinder (using original push rod). brake pedal sat too low and brake lights were on. pressed a hard...
yep, change the m/c for 4 wheel disc. easy enough to go power brakes at that point also.
you can adjust torsion bar height in front. looks like...
sounds like you got the wrong m/c. all 4 bolts should line up with existing holes. the plate on the firewall is reinforcement.
that is a vent for the rear axle. maybe overfilled rear? the front reservoir in your m/c is for the rear brakes, and rear is for front brakes. in...