Search results for query: *

Lol, now where have I seen this?................. Oh yeah! I have similar on my Barracuda that I've owned since late in '80. It is a lacquer paint that was done 76-77 (IICR) for a PO. 95% of time it's in garage and I really haven't noticed any peeling with it..............yet. :)

Little easier to read.........

I believe some mechanisms didn't have an alignment hole in the "R" tang. I think I'd just center it up with the other two. If the gate crossover hangs, adjust the "R" rod to where it doesn't. Always mark where your rod lengths are before adjusting JIC you need to get back there. Basic...

Yeah, you can do it! Angled HR pliers worked best for me. I took a lot of pictures before rippin' the old rings out for reference. Center the covers so the seats match the backs. You don't want offset seams. If you have buckets, try to match both the best you can. These were my first ever and...

Easy to make. .027" spring wire. Two and a half tight wraps around a 7/32" drill shank. Cut end lengths to fit tab and carb notch should do it for ya'. This one is heavier .032" SS wire I had laying around to try. Original.........

You might consider..... take a picture of your setup before you rip and tear. a means of keeping the gasket scrapings out of the pan. slinger orientation if you remove. give your gasket sealer time to setup before cranking it up.

So, it's not even on the engine yet? See post #4.

Post a couple pictures of your setup.

Maybe search "hook bolt". https://www.bing.com/images/search?q=Hook%20Bolts%20%20Steel&qs=n&form=QBIR&sp=-1&lq=0&pq=hook%20bolts%20%20steel&sc=6-17&cvid=C7BE5F95B26F49F1A38959512AD2855A&first=1

IMO, it seems logical if the valve is stuck to the filter inlet face it may not allow air flow through the filter possibly hindering oil pickup for the pump. Worth a check before install? BTW, I've always half-filled BB filters and spin 'em on as fast as possible. Then more clean up on aisle...

Hinged my grill side table....

Now ya' did 1991 cat)........

Before you rip and tear, you might check to make sure the fork is attached to the release bearing correctly. Both fork tips should be on the pads with the retainer springs holding both together. If one side of the fork is off the pad, you'll surely feel it in the pedal. A weak/broke/improperly...

If it's a cone, here's some rebuild info that may be some help. The 9-1/4 SG I had the pin was a slip fit.

Maybe spread a towel under the work to catch them slippery rascals! :)

You want ZERO leakage there. Not sure anyone can tell you just how much or how far you will be able to twist them in. IMO, a used tube has already been stressed and likely fit differently in another block. It may well take another turn. The quality of even a new China aftermarket tube may or...

Read post #13.

You've already verified the neutral gate is aligned more than once. A couple things I might try to isolate an issue before I rip and tear.... ...Setup a cam underneath to watch the shift linkage and verify the shift to 3rd is not trying to drag the 1-2 at all. ...Run it through the pattern then...

^^^^ There ya' go Don. @1968rt link shows 25 in stock. I believe they come "populated" as well.

Although not listing them right now, it might be worth calling Allstate on availability. https://allcarbs.com/?s=six+pack+float+bowl&post_type=product&type_aws=true Chi carb lists them. $$$ !! https://www.chicagocarburetor.com/carburetor-parts.php?c=2354 I used this bowl until I found a...