Separate names with a comma.
Here you go. Made 797 on the dyno.[ATTACH] [ATTACH]
Aside from bearing selection, is there truly any advantage going to an RB main bore?
So that is a stock block that has been cross drilled? I never knew you could do that.
I am guessing it now has billet mains then?
Take it from me, been there and don that. If I could do over I’d start with a good block.
Like others say. It can be done. For how long? My 400...
I have those in my 440. I run a 150 shot in that motor and have had no issues. For the price I think they are a decent piston.
[MEDIA]I run a 4:30 Dana. 4100 with me in it. Ran best of 10.14 at 133 on motor.
I have a street lynx 4 link in the rear.
Yes abandoned the Tremec years ago. Have a 727 in it running low 10’s on motor. Decided Racing was more fun than cruising.
Start by putting it in the car. ;)
I use a flexible Lokar dipstick. Attached it to inner fender. Works great.
I have a flat solid in a 440.
Howards Cam Solid 720152-08
.656 Intake Lift, .662 Exhaust Lift, with 1.6-1
260 Intake Open @ 26, Close @ 54, @...
Will get to run it again on the 28th. Gonna get to the scale to get an exact weight and have to check the stall in the converter yet. In my...
Send me a link to that bar. Thanks.
Spoke with Bill at RMS about it. He said 2 things.
I'll need a rear anti roll bar at that HP. He figured it would roll at that power. With my...
Yeah. A little suspension tuning and I need to figure out best place to shift at. I can go up with the timing a bit yet as I wanted it backed down...
Comp Mechanical Cam,
Custom Grind. 110 LSA
.608 lift Intake .634 lift Exhaust
108 Center Grind 6584/6586Castrol May 13...
I broke one axle and twisted 2 others in my 8 3/4 before I went to a Dana. 700 HP to an 8 3/4 is pushing the limits for sure.
If your gonna run...
I've always been told, the hotter the spark, the shorter the fuse. I think the HP levels as they get higher reflect directly towards its life...
Decide if you need pump gas or if you are willing to pay for race fuel. If you are willing to go race fuel then compression is the key. My 511 low...
The cam you put in your car isn't one that would strike me as one to file a lobe off. My solid flat is much more aggressive than yours and I'm not...