Search results for query: *

Thanks Guys! Followed the thread. Next up are power window switches to install.

What was supposed to be a quick install of the spring to start finishing off the trunk, ended up consuming my effort for 45 minutes without success. Tried wedging it open with a large screwdriver, and fitting it over the hoop on the trunk floor - No success! Tried holding it place and tried...

After a lot of delays, like moving across the state, I am trying to get my reassembly of my 69 Charger back on track, but have run into a roadblock. My original vent window assemblies were badly pitted, and I elected to just buy a set of aftermarket ones from Classic Industries. Looks like I...

Thanks for the correct name! With that info, I was able to find some on Amazon, and should get delivery tomorrow. Mike

Assembling my 69 Charger grill and cannot locate a source for the press on washers that go onto the headlight cover mounting posts. Anyone know of a source to get these? Already checked Lowes and Menard's with no luck. Mike

Thanks for all the info, will check those threads. Mike

No welded nut on the inner metal of the door. The nut on the front lower attachment is ready to go, as well as the small rectangular block and screw on the rear upper point. Have the lower post mount on the bottom of the door, and just need to cut some foam for ant-rattle. Have seen videos...

Getting ready to finally install the vent windows in my 69 Charger, and do not have the hardware that attaches thru the slot on the the upper front of the vent window assembly. Looks like it may be just a bolt, and a threaded clip that gets installed on the inner section of metal on the door...

Years ago I bought all new chrome trim to restore the grill on my 69 Charger. It has been stored in a box since I purchased it. Pulled it out today to start the restoration of the grill, and found that all of the trim now has a cloudy finish. Is this normal, and just requires some chrome polish...

Does it have to be OEM, or can you use an aftermarket piece?

Yes, I do.

1969 B-Body Disc/Drum Brake Master Cylinder, Distribution Valve, and 2 connecting brake lines. All New. Installed to check fit, but never used, and no brake fluid was run through the parts. Decided to go with aftermarket four-wheel disc system. $120

Hood to radiator support seal from 71 B-Body $30

Gas tank straps for 71 B-Body $30

Vertical radiator support from a 1971 Satellite. Will fit Road Runners, GTX's, and possible Chargers of that same body style. $30

71 B-Body Driver's Interior Door Handle. Like new repo that was not used. $25

Throttle Cable for 71 B-Body 22.5 Inches long $35

71-74 B-Body Trunk Lid Latch Plate & Bolts $25

2-Speed wiper arms, pivots, eccentric, rubber boot cover, and misc parts from a 71 B-Body $75

If that does not pan out, I have the Driver's side only available. Asking $30. Mike