Separate names with a comma.
If clones were just over 20 a numbers matching descent bee like this one realistically starts with a 3 in front of it. IMHO.
If the missing parts are there maybe around 30k...
Well, because you’re thinking about it now, I understand, you might as well go get a set of gaskets and check it or else it will drive you nuts,...
33 IMP has a good suggestion, and is just trying to save you a lot of time and hassle. If the car makes pressure they’re in, if it doesn’t they’re...
My block was cast 12 11 68, stamped December 27 1969, and I have no reason to believe why it wasn’t out Ina fury 4 door as an HP motor. If you...
My Runner was January production, a month earlier.
That wouldn’t be a vent then. You described a closed loop.
You’d think with your grill you could just run it at high for 1/2 hour and scrape the grill, that should disinfect it? Kind of a piss off though!
So I double checked, yes it has the full VIN in the block and trans too. 69 lynch road car, road runner, sold new in Vancouver Canada
@dadsbee is correct. R is for Windsor plant. My 69 runner is also Lynch Road car built for Canada, sold new in Vancouver, and has the full vin...
Both my 383 have full vins down by the oil pan.This one was from a more door car, I’m thinking factory cop car? [ATTACH] [ATTACH][ATTACH]
I don’t know why this works but I do it too, also in my travel trailer and never have mice issues. The one time I stored my travel trailer at a...
The oem set up is that the tip hooks to the bracket as per my photos. When I install mine it’s tail pipes only, no tips so our set up differ...
How big is the hole where it would thread Into, perhaps you can use a large self tapping bolt, I would run a tap through it though, or, if perhaps...
Just watched grave yard cars and they disassembled an original painted orange Daytona, and apparently, according to Mark, the would assemble the...
Okay here is what I have deduced from this. First, your instructions highlight a different style hanger than the one you have installed, shown...
I’m out right now but will photograph a picture of my frame rails and the supplies bracket. Looks different from yours?
The sell them new? Still available..Or, are you looking for just one only?
Is the highest point of the tailpipe currently over the Center of the axle? If it is also about 3” too far forward you definitely have to move...
All of this got me thinking about my up and coming install, so I went to look for the instructions and I didn’t get any with mine. Can post those...
