Separate names with a comma.
Seems pretty high price to me? Looking at that bolt through the upper control are, I'm curious what else is screwed up on the car?
On my 360, the heads and block were milled, and the intake sat so low the ends were almost touching. I only used some RTV on the ends, no room...
Drop the intake on without gaskets and check the location of the head bolt holes to the intake holes. If the head hole is partly covered by the...
As mentioned, the heads are cast to be used on either side of the engine. The water flows from the lower radiator hose into the pump, and the pump...
Thanks for the comparison. For me the Spiro-core worked fine, but I fried a few boots (383 B Block), and after a few years of taking them on and...
Found this on the Blue Max Wires:https://www.moroso.com/pub/media/wysiwyg/Charts/BlueMax-SpiralUniversal.pdf
Depends on which version. The regular 7mm small block from Mancinni are $90.95 https://www.manciniracing.com/marafafitfiw2.htmlHave any...
My normal performance go to wires are the MSD Super Conductor with multi-angle ends, but they are around $100. I usually end up cutting them to...
If you just want something that fits, most muffler shops can bend up a system, or you could piece together some stock replacement parts, but those...
The small hole may delay warmup, but likely not much. It is there to get the air out of the cooling system when filling it.
Call http://www.rtspecialties.net/ PH: (570) 388-1082They had them for my '69 Convertible.
As mentioned the R/T came standard with the 440 engine with 426 Hemi as an option. The were a higher trim level vehicle also like the Coronet...
Gopro Quick editor. The gopro 5 black I used has GPS and will display even more telemetry, but I did not want to display speed, gforce, and such.
Don't have any cruising, but short clip of testing the FiTech EFI. [MEDIA]
On the 1969 Coronet R/T Convertible, I currently have the six pack style hood (steel hood with fiberglass scoop) on the car that I used when i had...
Asking here is a good start. If there are Mopar car clubs or speeds shops in your area, go and ask around. Leave a card with contact info. I...
Yes! I rebuilt my '69 R/T 11" drum brakes with the '70 self adjusting hardware and it works.
Get an Extra Deep socket 9/16" socket (about $20), it makes the job easier. I used my old straps with the tank that had the sump welded on, and...
Thanks all. I know what my next project is.
Might be a good idea to just remove the pedal assembly, then I can clean it up and paint it. Does the assembly have a return spring too. I...
