Search results for query: *

Man, I’m still amazed at what this community was able to do. First off - Bill. I’m not sure how I can say thank you. Mike and I have chatted daily since the show and this is without one of his happiest moments he’s had. Just knowing that 20+ years of history don’t go to waste and the car was...

Of four possible positions, only one is correct and all four holes line up. And if that is a cast crank motor, a counterweighted converter in the wrong place will knock your fillings out. On my converters and flex plates, I always put a paint mark on the offset hole in both. ( mopars are kinda...

I really like this thread it’s gonna help a lot, thank you

welcome to FBBO from Pa

Yep, the seller is restoring a 73 GTX asked me to double check. Definitely appreciate your help .

Because you said that, I'm going to get 5/16 bolt from Lowes tomorrow and see what happens. But will 3 of 4 line up with the 4th one not aligned?

It will with the van shifter handle and a small block 4-spd OD bell housing.

No idea about part #?? For my 70RR it had the wrong Z-bar that pushed the rod in a sideways direction rather than straight back breaking the mounting stem on the bell housing. Fortunately a local Mopar guru showed me (3) Z-bars all the same width but the mounting tab that pushed the rod were in...

How do you guys tell your wife it's too cold outside to put up Christmas decorations while your outside under the car working on it? :lol:

Had a set of Brand new Super Comp Hooker headers done many years ago.. Nothing but problems they were done by Jet-Hot outfit in Bridgeport Pa. They ultimately rotted out completely in a few years. Afterwards they did ANOTHER new set for free inside and out as they stated the ones they did the...

Welcome from the central coast of Cal. Watch your feet.:lol:

Will one hole not line up when the other 3 will?

I went and ordered both sizes. The 5/16 will come on Sunday and the 7/16 on Tuesday. Let’s see which one fits.

G'day from Australia :welcome:

Welcome from AZ... :usflag:

:popcorn: You would certainly think some of the Max Wedge boys have done it....or at least with very similar heads with the aluminum stands.

My wife takes Halloween down and puts Christmas up. My favorite time of the year.

If it has the blue FelPro 8519 or 1009 gaskets on it now, that's what you should use on it. Two years ago I honed a .030 over 440 with a plate in my shop using a Felpro gasket, knowing that the customer was going to be using them when he put the heads on as I built the short block. I got most of...

Great story on the cropduster, thx for video. Frieburger and Dulcich talking mopar, probably the only 2 guys I'd listen to for over an hour non-stop.