Search results for query: *

I don't think this guy was going to talk his way out of a ticket.

I was born a poor black child....

you could fill it, even body filler won't "chip off"........ but in that situation, I usually drill the spot out welds and adjust the hood skin on the frame

I was born penniless, and have managed to hang on to most of it.

That would work, but I think the block deck and heads would have to be surfaced for the mls gasket.

I like your cam specs (close to a Howards hydro I have in a 400), but I really want to avoid hydraulic lifters on this build.

Good advice, but I didn't want to go full machine shop mode on this project. Forged pistons would require a hone to fit for piston to wall clearance or possibly another over bore if I raised the CH, and then some aftermarket con rods and rotating assembly balance for sure. Might as well have...

...advance amount but wasn't sure by how much. You can see the welds here. When I had the engine on the dyno, it was checked and there is 20* mechanical advance. But since my engine has the KB107 pistons in it and they are hypereutectic - I've read that total timing shouldn't exceed 34* when...

Would you happen to know where these brackets go? Thanks in advance. I'll set up a Member's Restoration thread when we get it all back together.

Local John Deere dealer, Blitz Black works too. If you want spray can or shoot it from a gun.

Not sure this is a good idea or not but I’ll throw it out for comment - high strength, 2-part panel bonding adhesive feathered on, like 3M, 07333. That stuff is tough. Block area afterwards with thin coat of high quality filler like Rage.

Case is grounded to firewall and engine block. What I am confused about is the alternator wiring which is correct

Sparkplug brackets changed some year to year, but the heatshields were the same I think.

@Skytrooper :bday: :bday: :bday:

No. No other numbers. Engine is installed, difficult to look behind 2 1/4" tubes, but no stamped numbers on passenger side, just the engine part number and a 1. Day shift. No numbers by either one of the oil pressure ports.

I have door panels from a 66 Satellite. They need to be recovered. I'll take some pictures the next time I get to my storage locker.

you can reconnect your battery now

R.I.P.

You could run Cometic mls head gasket. They make one .027 thick

So someone pointed out in here that I didn’t even purchase the correct headers. The ones I purchased won’t work with power steering. I am keeping my stock exhaust manifolds. To your point my engine is mostly stock. I thought I was doing something the simple way until I posted this thread. Always...