Separate names with a comma.
If you are dropping them in vs. on the K from under, better to install the shifter after.To simplify installation, set up the shifter and rods...
If they get it took hook once it gets rolling, absolutely. But we're just guessing. The guys at Hotrod should have explained it. They know better....
Looking at the car my guess is lack of traction = the bad times. Its not the engine build.
Just a gasket and some silicon for the gear set. You can reuse the gear oil if clean enough. If you put new in and use a suregrip, be sure the...
On my 72 I used stock rods and levers on the OD trans and everything worked fine.
Its actually supposed to have a little play even with everything fresh.
Have done it on circle track cars and demo cars. I would never do it to a car that is driven on the street.
You are fighting the same gravity for half the strokes in either scenario.
No - gear ratio is gear ratio, then the tires are driven. Then tire diameter can effect RPM.It's all relative anyway. The original tire diameter...
Pretty sure you had meant 60 series tires. Between the two, considering OD, definitely the 3.55s.If you are willing to consider other gears....
...and how tall are your rear tires? .... and what is the typical highway speed limit in your neck of the woods? .... and how far/how often do...
Cut off the oil bung and weld a 90' degree pipe and straight extension with and NTP end so that you can connect to to it with a straight fitting?
I would also say 3.23 is the most common.
Well... that's all they had in the old school days. I'm guessing the manf date was maybe October 1983?[ATTACH]
About 22-23 years ago I got a "built" 1966 383 in a trade deal. I disassembled, honed the cylinders, and installed new bearing on the rods and...
I didn't take any pics and its is now back together. It was the stock 3/8 size.The Miloden pickup tube is made of a higher strength material...
Thanks for the replies.I did read elsewhere that it is NPS 3/8 in stock form.I took a break for awhile and hit it again: I tapered the last...
Changing the oil pan in the car (73 Charger 440), when I removed the pickup tube I noted that the end of the threaded hole in the block is quite...
Paul, Tha A-body axle is narrower than the 67 B housing so you will be gaining outer tire clearance and losing inner clearance no matter.
