Separate names with a comma.
Do you have a part nu,ber for that pan?
https://www.summitracing.com/parts/mil-31581I like the external pickup version.
Did you check the clutch disc air gap with a feeler gauge to ensure there is sufficient clearance? If the bellhousing runout is out of spec you...
Can you still buy them from mopar? Do you have a link?
1) they are readily available in 2021 2) you don't need a dowel puller to remove then 3) they are the correct size (not .500) 4) they are easily...
Damn...5? Is there a minimum word count?
The Rob MC dowels are what you want to use. Nothing finer in my opinion.
This is why you always see '66-67 b bodies with a hood scoop. No clearance for anything beyond the standard Performer intake if you run a decent...
I prefer the Hurst shifter. If you are after authenticity buy a Hurst mechanism that accepts the Inlamd handle from Brewers. Just one guy's opinion.
That is a 10.5" clutch fork.Get a new Hurst shifter, you will thank me.
A clutch disc dragging will make it hard to shift into reverse and 1st as described.
There is no input bushing on an a-833, only a bearing held in by a snap ring. Did you check the runout on the bellhousing?I agree that the...
I just recieved the bracket set that Andy linked. This is my go-to for low and mid rise intakes. Awesome stuff! How in the hell could you screw...
Make sure the bellhousing is square to the block and aligned to the crank center line while it is apart.
1) That gasket is not a good fit for the stock stamped oil pan. IIRC the corners are an issue? Maybe put superformance gaskets on both sides to...
I have replaced them in several a833 4 speeds. Cool tool thanks for the info.
Nice work!
I use a section of conduit lightly chamfered on the ends. It really helps to use an assembly grease in lieu of the normal axle grease. Axle...
4.2 qts
What does the FSM say on the subject?
