Separate names with a comma.
get the gasket and see how it matches up.
well that is one way to keep the bugs out of your teeth.:lol::lol:
you need a hammer drill and cement anchors that go at least [i think ] 3 inch in the cement hammer in and tighten down to spec.
look on the Edelbrock forum they have all the info for what you want to do . i also have the pro-flow 4 xt system
even a blind squirrel gets a nut some time.:elmer::elmer:
save pic in your p c picture file then click on upload photos and pick the pic you want then the size and done.
get some modeling clay put on cover then install on engine then remove and mic the clay thickness for what your clearness is.
there are many factors that make a car to be what you want . so what do you want to do ?
street or strip j m o a race car is not good on the...
so with seven hundred lift 900 c f m is enough fuel ?
going over to much with cam for a vacuum operated carbs you better be good at tuning them.
r/t specialist great kits
on to each is given a talent and to shear it is how to have it carries on.
i found this
The Transient Voltage Suppressor diode (also known as a TVS Diode) is a protection diode designed to protect electronic circuits...
OK then what dose it suppressed ?
a/c clutch is 12 volt
would that be for noise in system ?
gm / chrysler made a ground temp switch use as trigger for on of the fan and the fan can be powered all the time look on you tube for wiring a...
it takes less voltage to ground a circuit than to power it. most new cars fan control's are done that way for longer life of the fan and relays.
all you do is remove screw from t-handle slide up to remove then slide the 45 pistol grip shift'er on to the shaft install screw and...