Separate names with a comma.
No the drip rail has to be last
it goes over the small side piece
Start with the bottom piece then the upright piece at the back of the window and...
I just bought a new Strange Engineering driveshaft for my charger from Doctor Diff
The instructions on the Doctor Diff site are to measure from...
Okay we dropped the driveshaft today and pushed it all the way in
it still had machined surface showing at about .5 inch
So my actually travel...
We are going to drop the driveshaft tonight and remeasure
However I am certain now that what I have is correct
As Fran Blocker pointed out the...
It is longer than your measurements (51.75)
Strange wanted it measured a certain way
I measured three times and sent it in
The one they sent c to...
Fran your picture helped
I had found another measurement while surfing the net that said the U-joint center should be at 3.75 inches from the Tail...
full weight on the ground
I got my new driveshaft in the car today and I have 1.75 inches sticking out of the Tail shaft of my transmission
is this too far out?[ATTACH]
Just switch to Hagerty
why worry about hiding it, hoping they don't notice, or even lying about it
PM sent on the rear quarter window trim
Thats what I thought too
until I twisted the drive shaft out of my car on the chassis dyno
Destroyed the custom exhaust tooAs for the original...
I received my Spoiler today
It's absolutely beautifulI am extremely pleased and cant wait to get it on my car
if I remember correctly there are a number of idler arms that will fit but not give you full clearance
A fast ratio pitman arm can be another...
That is a question you need to call and ask customer service
with my 66 Charger the lead that went to the heater fan was not included
Nice and simple
I twisted the driveshaft out of my 66 Charger while on the dyno (u-Joint failure)
I am looking at a Driveshaft from PST with 1350 U-jointsMy...
Make sure you get it right
not just okay or it will workThis is the result of U-joint failure
it happened while on the dyno
And it's going to...
Michael has posted several times about his progress
He posted this 2 Days ago
"1966 1967 NASCAR spoiler update, the Machine Shop said that a third...
VHT makes a silver ceramic coat that I have used on headers and it held up very well