Separate names with a comma.
That electronic equipment was worth about 5k before it hit the pavement at highway speed.
I have had good luck welding a large bolt into the fitting, leave it standing a little tall and do the weld underneath the hex of the bolt. But...
That really sucks, Bio. For the electric fans on your RR, you could mount them to the front of the radiator, sans the box shroud, until you figure...
I've done homemade shelving on teh header panel above the door and liked it. Obviously cannot access any of that if the door is up. Similar...
I've bought replacement hoses that have the spring in them, why would they include it then?
Vs the picture I posted earlier - your box shroud, even for the 2 larger fans, is still blocking a lot of air, and the single 16" is even worse....
I've not heard that before, but I surely don't know everything. But I would think the head pressure of coolant above the lower hose would make a...
And that can cause aftermarket parts that get good reviews in run-of-the-mill installations to not work well on the edge. Or a combination of good...
Does your setup look comparable to this one?[ATTACH]
Agreed on the spring, especially if you decrease the clearance on the water pump impeller, as that will create more coolant flow, and increase...
What this statement usually means is that at higher speed, the ram-air effect of the vehicle moving through the air is sufficient and a fan is not...
My thoughts, from 25 years of working/learnign on cars, 25 years as an engineer, and a few years working as an engineer at a cooling-fan...
Perfect combo of stance, filling the wheelwells, tire dia, and sidewall height. Love it!
YeahNow that you mention it, mine would avg 18-19mpg too.
If going with a Magnum (5.2 or 5.9?) have you considered using an A500 and beef it up a bit? It is shorter, so it moves the OD section further...
Back when I was in high school, my 1st car was a 77 Cordoba with 400-4 and 2.45 gears.In Drive, I could get a FT downshift into 1st at around 25...
