Search results for query: *

Anyone know of a vendor that will re anodize these Moroso valve covers?? Picked them up at a swap meet and used Purple power to clean the grease off and it took off the gold anodizing.

Can anyone tell me the torque rating for the aluminum intake manifold bolts, i cant seem to find it in my service manual.

Looking for any information on 69 1/2 Six Pack Bee WM23M9A255804 Believed to have come out of Texas in the late 90's early 2000

Looking for a 69 Super Bee factory drive shaft, length 50.96''. I cant seem to find the 69 part number, but the 68 is 2852326 50.96 X 3'' 7290 joints.

Looking for the upper behind headlight metal splash shields for 69 BEE. cant seem to find reproductions for these

Can anyone tell me if a V-8 K-member is the same for big and small block? I need a 69 big block k-member and just want to make sure im looking for the right part,

Looking for 69 B-body big block k-member, preferably early date code, but would consider any date

Can anyone yell me if there is a rubber/metal shield that attaches directly in front of the front tire? It would attach to the bottom of the fender headlamp bucket area down to the rear edge of the valance to keep mud/water off of the lower front turn signal. I have the front end apart on my 68...

Can anyone tell me the correct colors for the ID marks on 1968 780/781 torsion bars?

In replacing the rubber gasket under my wiper motor, I noticed the metal sleeves, or "crush sleeves" as I've heard them called, that slip over the stud and into the gasket are missing. Does anyone know if these are available? I see them for the chevy's and fords, but no mopars.

Was at the red barns show today and stumbled upon a 69 Hemi road runner for sale. anyone know who owns it? info said Bob Wills from Battle creek

Any one have a thermoquad air door tool for sale? C-4152 is the Chrysler part number

Was installing a driveshaft loop on my Charger today and noticed that the driveshaft has 2 steps in the diameter at one end. I did not measure the diameters, but approx. 8-10" from one end it steps up, then another 8-10"it steps up again. I am wondering if there is a correct installation...

Complete unused 5 book set of 2006 SRT8 service manuals. 250.00 plus shipping. Negotiable.

Pulled the starter off the 68 hemi while the trans is out and need help identifying what its from. The nose cone # is G2342928 and the case is 1889100. I've found the case number identified as a Chrysler replacement motor, but cant find the nose cone number. I purchased new fasteners and the...

Looking through the paperwork with my 68 Hemi Charger, and I have a few title transfers with previous owners names. Wondering if anyone knows any of these people. J. Perry jr Scottsdale Arizona, owner in 70's Anthony Ludovico Glendale Arizona, owner early 80's Richard H. Kirchhoff...

Getting ready to install the correct Bendix booster and drum brake master cylinder. I know the booster is painted black, but unsure of the booster mount/lever assembly. Currently the lever assembly is natural steel as well as the drum master cylinder. I have read that the master cylinder is also...

So are the air filters available for the round chrome Hemi air cleaners? 66 through 69 I believe. I cant seem to find them anywhere.

I just picked up an original 68 Charger RT Hemi 4 speed, and have some questions on the correct operation of the choke and AFB carbs. The rear AFB 4431 has been modified to an electric choke, and I'm trying to get it back to the correct 1/4'' heat tube/tubes. currently I only have one tube that...

Wanted Complete set of big block stamped steel rocker arms