Search results for query: *

Hey guys, I have 906 cast iron heads and the old cork valve cover gaskets were getting pretty ratty so I thought I’d try the Moroso blue rubber gaskets…they leaked like crazy on both sides and I attributed that to the imperfections of the cast iron mating surface. So I’m back to a new set of...

Hey guys, trying to dial in again after modifying a few things on my Holley 750 DP….I have timing at 16 initial, 33 total with vac advance disconnected. It could use a bit (a lot) more although I haven’t test driven yet since getting it back together and stopped for the night. PROBLEM: when...

Hey guys - just for my own information, does anyone know what harmonic damper I have on my 440? I’m also curious why it has 2 timing marks. The main ring is 7/8” thick. It’s obviously been around a while judging by the layers of paint…car was listed with a “steel” crank when purchased but...

Hey guys- I’m trying to go through and fix leaks and I thought I would double check the oil pressure gauge fittings at the back of the block. One port has a line to my mechanical oil pressure gauge and the other has a Y with a KYSOR pressurestat and the other is a sensor wired to the dash oil...

Howdy- Does anyone have a good source for ‘65 Coronet split bench seat covers? Seems hardtop/500 bucket seat covers are readily available but I cannot find any repro covers. I currently have cheapos over the original covers but want it more correct. Need a black set….thx in advance!

Does anyone know where the Alter Bridge is in Detroit? I’ve heard many stories about many dudes jumping it successfully and some unsuccessfully (oil pan meets crank). Maybe more popular with motorcycles but i would bet a few b bodies flew over it after a couple of Stroh’s… Apparently there was...

Hey there - I have a 1965 Coronet with a stock gas gauge that always shows past full as far as the needle will go. When ignition is off the needle sits on E but when ignition is turned on, the needle sweeps up, pulses a bit and pegs past full and stays there (looks more like a blood pressure...

Hey there- I have a Dana 60 with 4.10 gear and 38 spline axles. I did not install this axle it was already installed when the car was purchased. I noticed that there is a good 1/2” of play in and out when I pull on the axle. I though the brake assembly was the only thing holding it in so I...

Hey there I have a 65 Coronet post. Anyone know of a driver side side mirror that attaches to the door frame somehow in front of or behind the vent window? The car has never had side mirrors and I don’t want to drill into the door for stock mirrors…

Hey there…does anyone know a reputable exhaust shop in Atlanta area Georgia? Looking to change up the configuration of my current setup…dumps just before the axle and I want to extend to rear exit under bumper…thx!

Hello! I am looking for a 1965 Coronet driver non-project of any trim level (440, 500 etc). I prefer a post roof but open to hardtop as well. Will travel to you. Thx!