Search results for query: *

Never ran into this problem before but the groove on the steering box input shaft does not line up correctly with the hole in the steering shaft coupler roll pin hole. This a factory column and coupler as well as power steering gear. I am attaching a pic of the roll pin that came out during...

Wonder why Tony D’Agostino isn’t posting all his parts for sale here yet?

Some have probably seen this but I hadn’t

I got my old Marshall rig back after about 10 years. I regretted ever selling it so last week the guy I sold it to asked me if I wanted it back. Needless to say,I obliged him. It is a JCM 2000 DSL 50 watt that has had mods done and sounds awesome! The cab is a vintage 1960BHW 4x10 120watt.

My smiley faces or bold or anything at the top of the reply box isn’t working. When I tap on them they give indication of being tapped but nothing happens. They work like normal for me over on FABO

Installed new gearbox and pump and new lines on my 69’ bee. Can I vacuum fill the system before start up? As in pull vacuum on the return port on the box and through the pressure line and pump keeping the fluid level in the reservoir above the pump. Planned to use a length of hose connected to...

Looking for LH A pillar trim for a 1969 super bee color doesn’t matter but the interior is dark blue. Doesn’t have to be perfect just usable. thanks

Any chance someone out there has the matching water temp gauge to the ones pictured they would be willing to sell?

Could someone hook me up with a nice center section grill for my super bee. I have one but it has a few issues and hoping I can find a nice one I can polish and paint just want one that’s straight and not broken and all the tabs are good on it. thanks

I have two 650 AVS 2 carbs and my intake is a dual plane with 4 hole plenum openings for each carb. Would using a gasket with the open design like for a single plane intake vs a 4 hole gasket make any difference in the velocity or the vacuum draw on the air bleeds etc. here’s a pic of the carb base.

Looking for a bulkhead connector for the wiper motor harness pretty standard but for a 69’ coronet. thanks

could someone post up a good pic of a 69 hemi wiring harness focusing on the ballast resistor and voltage regulator wires. thanks

Any of you guys used or have experience with the reproduction battery cables that Layson’s offer.

This is aggravating! I rebuilt my A833 gearbox and used all new gaskets from brewers and I filled it with oil and there’s a dang leak around the reverse detent housing to case gasket. So now drain all the oil back out to remove the sucker and try to figure out how to be certain it’s sealed this...

What size is the smaller wire on the positive cable that comes from the battery and connects to start relay and the one that goes from relay to starter solenoid? I’m gonna make my battery cables for my Hemi I can’t find one that I can trust and Frank Badalson is out of them and M&H says they...

Can someone give me the part number for a big block stant 180 degree superstat?

Looking for a 35 tooth speedometer gear for an A833 trans I have a 32 tooth to trade if someone needs it. thanks

Where is everyone running the oil line and thermocouple wire through to the interior?

Looking for an original or correct rear brake proportioning valve that goes in the rear line and mounts on the frame rail below the floor pan. Pic for reference please let me know if you have one available thanks

Never will understand why someone goes to the trouble to reproduce a part and doesn't get it right! I guess the Chinese lose the specs in translation check out the pics of the flare seat in the new repop compared to and original brake valve. It does not match the flare at all in fact the only...