Search results for query: *

1965 Dodge 383 2 bbl, complete air cleaner to oil pan (except power steering pump...damaged when pulled), turns freely, 100% stock, ran when pulled, been inside since pulled, Local pickup only. I have an engine hoist to help load. Engine stand not included. Located in Conowingo, MD. Please...

I'm having an issue with my top tank seam splitting in my Coronet. This is the second radiator, and the fourth time it's happened. And I found another one on eBay same problem. Anybody else having this issue? Or know about this issue? I'm really confused as to why it's happening. I'm not using a...

I had a problem a couple of years ago with a leaking heater control valve...basically if you got anywhere close to the fun side of 3 grand, is would pi$$ on your right foot. So I pulled the heater box and worked on solving the problem. Since a convertible doesn't really need heat, I left it out...

Just recently finished building a 392 Poly Stroker. Final numbers from the dyno are... 405 HP @ 4900 rpm 472 LB/FT @ 4100 rpm

I wasn't sure if this should be posted in the tires section but it's 62-65 specific. I'm getting ready to buy Magnum 500's for my 65 Coronet 500 'vert. I test fit 275/60/15's on 8" wheels, but I only have 3/4" between the outer sidewall & the outer face of the wheelwell. Because of this, I'm...

Due to an unfortunate incident involving a remote starter switch, my garage door frame, and my 65 Coronet 500 'vert, I need a RF fender, RF wheel well trim, and the RF long fender trim for a 500 model car. I live in northeastern MD and will be going to Carlisle on July 11th.

I'm trying what to do about wheels & tires on my 65 Coronet 500 'vert. http://1962to1965mopar.ornocar.com/mmo62008.html Anyone have any other ideas besides the ones above? There's only a few aftermarket wheels I like and the Torque-Thrust's are one of those few. I'm probably going to do...

Just thought I'd show you guys some before & after pics of my motor project in the Coronet. I still have to paint and install the radiator, install & hook up the distributor & ignition, change the oil, plumb the carb, and hook up the throttle linkage, etc...but it's getting close. Sorry about...

So I dove into a cam swap project on the poly 318 in my 65 Coronet over the Christmas holiday. When I got the top and front of the motor torn apart, and was ready to pull the cam, I noticed a diamond stamped in to the right deck on the block. To make a really long story short, it means that this...

Hey Everyone! I'm another transplant from FABO. I'm not as active as I would like to be on the forums I belong to anymore due to being so busy @ work and home, but I still try and get on now and again. I've got a 65 Coronet 500 Convertible, 82K Miles, 318 Poly, 727, 8.75 w/ 2.93's, Gold...