Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
If anyone knows of anyone coming back from the west coast to the midwest. I have a pair of fenders I need shipped. Coming from Arizona to Wisconsin. I would even meet in Chicago if needed. Any help would be greatly appreciated!
Thank you for the reply... I would think if I did that there would be other problems like noise from springs hitting something inside. I have nothing like that.
Just recently did an engine swap on my 69 charger. It needed a new clutch as well. Purchased a new dual friction clutch when the new motor went in. Just recently put everything togather and pedal doesn't feel right. I've done more than a few of these over the years and something is not right...
Running the Torker II on a charger. Anyone running this intake? What length throttle cable are you running? Mancini is out of them... Any suggestions on another place?
Thanks in advance!
There are two machine screws on the back of the headlight door. You can very carefully hold the door up while you get to the screws. You need a 90 degree angle screw driver to get behind there. A friend let me use his. Since then Ive been to my snap on guy who tells me they don't make those. Not...
Just put a new motor in charger and finally got to where I could run it for first time today. Other than new motor nothing has changed other than a new coil and lengthening the two coil wires for the coil due to not being mounted on intake. All I have is a test light and have a weak signal to...
According to my other car which is a 69 charger that v plug runs back to the 4 speed light. Following the wiring diagram says that also. I dont have that connector on either car.
I'm putting a car together that someone else had their hands in and probably didn't know what they were doing. (I'm sure most of you experienced this at one time when you bought an unfinished project.)
Tried putting the drive shift in after a motor swap and noticed the fit wasn't right. My yoke...