Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Thats a Motorola unit that was an option on many early 60's vehicles. My 64 Polara came from the factory with one and i'm just getting ready to re-install it after complete re-paint. This unit is only part of the system. In addition to that you need the under dash mounted box which contains the...
I have a 64 Polara and my question is regarding the plastic portion of the steering wheel. Did Mopar use the same basic plastic steering wheel on the 65 Coronet. I realize the horn rings and center emblems are different.
Found a really nice 65 coronet steering wheel (bare plastic portion only)...
I have a wierd/strange water pump pulley that has an internal spacer spot welded on the inside of the mounting surface. Has original orange paint (unknown origin and don't know what it came off of ? Could be slant 6, 318, 340, 383, 400, 440 ? Measures 2.75 tall and 5.75 O.D.
Is this something...
How did you get the roll pin out ? I've tried the smallest punch I have and also a ground down nail and only got it to move about 1/8" Any ideas ? 64 Polara
Thanks
# 1 - I'm using a cast iron 62-64 water pump housing 2205862. My federal ps pump bolted right up but the pulley does not line up with the 2 groove crank pulley I have installed. Originally the 413 that I'm working on had a 4 groove crank pulley & by doing a quick measurement that pulley would...
Recommendations for fuel pump push rod needed to complete engine build. Plan on using Holley 12-440-11 mechanical fuel pump.
Engine block is 1974
I believe the correct fuel pump push rod length is 3.220
I have removed the vent glass frame assembly from both doors. There are 2 visible screws attaching the glass to the frame.
How do you remove the latch ? I don't see a set screw or any other fastener holding it to the glass.
Help
The sc bracket that bolts to the retainer ring is approx 1.5" wide and since you only have 1" will have to be cut down to fit. Could easily done.
Good luck