Search results for query: *

How are you fitting the seals together?

Complete girdle with all studs and washers, pan studs, ect. $375.00 Plus shipping.

Has anyone seen this on a oil slinger before?

Would you use a gasket between the girdle and pan? Or just a bead of Right stuff? ( Yes I know you need a light coat of sealer between the girdle and block)

Came from running engine 2yrs ago. $300.00 OBO Plus Shipping located allentown,pa

Have a 70 b block 727, want to add part throttle kick down. Can I just take a valve body from a 72-80 non lock and swap it out?

Anybody know of the part make and part number of a u joint that will fit the 3/4 diameter shaft at the coupler end the d shaped end? A standard 3/4 double d the flats are not wide enough to allow the double d to slide on. Do not want the factory couplers.

Can anyone supply the measurement of the drivers side holes for the radiator? need a measurement from the top of frame under battery to the center line of the holes.

What I have 505 short block flat top pistons 0 deck . Looking for street driving options. I have a holley sniper and complete in tank fuel system, holley hyper spark ignition, TTI 2" header and 3" exhaust, 9 1/2" converter. Looking for suggestions on HEAD and Cam options. Do not want...

I am replacing the lense in the bezel, What is the suggested glue or epoxy to hold it in place???

What is everyone using for the after pump 10 micron fuel filter? Part numbers, photo's of installation ?

Are these available for sale?

What single plane intake for a 440 will fit under a stock hood on 1966 dodge coronet?

Anyone know how the clock spring is secured? The needle will not return to o .

Can anyone tell me how to remove the valve section from the 800126 box? This is the part that the lines are connected to, the part is held on with 4 bolts. Will this just pull off over the steering shaft when unbolted. Is the any rebuild instruction published anywhere? The internet returns no...

Working on 66 coronet and would like to see some photos of the package tray and back top of rear seat, how did they trim this area? also does the package tray sit on top of the quarter trim panels? Any help would be appreciated.

Which way do the bushings go?

Does anyone know where to get the felt washer that go on the linkage ends? they are about 3/4 od with a 3/8 hole and about .100 thick

Need help to identify cam. On end of cam ISKY X10 C 23223 BO S 523 14 08 S 504...

This alt puts out 14.6 volts. Voltage to trunk battery 14.5 Volts at fire wall and dash 14.5 to 14.6 Is there any way to reduce the volt output of alternator? Even when the headlight and the wipers and the heater are on it still puts out 14.5 volts. Amps are not the problem, Battery...