Search results for query: *

I have the same problem going on with my new MC I just bought now with the center hole being a little bigger then the MC I took off. Did you leave it like that or get another MC? Thanks, Dave

I got it off. Them damn nuts were directly above the pedal assembly and all I could do is feel them and I could barely se them.

I know about those, just try to get to the nuts behind them to take it off. I do believe they are the two top holding the pedal assembly on. Thank you, Dave

I haven't found anything under the dash and up near the firewall that isn't a bitch to get to! That is about where those should be.

Hi Guy's, It's been a few years since I needed your all's help but I am having problems on how to remove the master cylinder reinforcement plate on my 69 Superbee with Manual drum brakes. I have the nut off on the engine side but whatever is holding it on the inside, I can't seem to locate...

Yep! I got that one on Tuesday. I haven't been to a car show all year, Glad I bought a Harley late last year at least I have something to play with. The Superbee has been down for weeks!

Craig, Will you be at the MoparNats by any chance? Dave

I checked these guy's out and they are a little pricey on their brake shoes. For 4 wheels the shoes are $250.00 that's not including hardware. Thanks! Dave

Looking to buy new shoes for my Super bee, any recommendations on who to buy from? Rockauto a good place for brake shoes? Thanks! Dave

Thanks dadsbee! You are one of the ones I was speaking of that had this same problem. I did call ECS last week and they wanted 240.00 and shipping was 50.00 I think of course I was going to buy their vent wing window that was only 55.00 that was non date coded prices

I'm not even sure where to start with this issue I or we are having with sedan door window replacements for 69 Super Bee. I am so sick and tired of ordering parts and not fitting or holes in wrong location, my title should have been cuz words! Here's the problem and I know at least two on here...

I will share a little secret with timing tape. I put one on my 69 Superbee 383 after the rebuild in 2012 and it is still on. Before I put in on I new about it not staying on so I applied a little super glue on the end where is starts then put in on around the balancer and put some on the end of...

Thanks guy's for the replies, I am not sure if I got rubber or poly damn!

Hi guy's, Question, I am in the process of installing new sway bar bushings and I am getting ready to paint. Should I paint the bar and bracket separately or install bushings in brackets first then slid them up to there position then paint? Or slid bushings on bar first then brackets onto...

I maybe wrong but if this is an automatic why is the starter relay for a manual with the yellow wire or am I loosing it?

Thank you everyone for the comments/advice. I thought of purchasing the fel pro 1214 with crossovers blocked and drilling about a 1/2 hole to let some heat through and using the sealer. I'm just not sure which sealer to use and everybody and their brother uses different sealers. Thanks again...

Hey all, I have a 69 383 and last fall I pulled the aluminum intake off and proceeded to put a new valley pan gasket on and put my factory cast iron intake on to see how it runs. Now I am ready to install a new aluminum intake and the question is since I have already torqued down the bolts to 40...

So it looks like my cable is bent out of shape and not even fed through the hook. Looks like I'll have to look for the proper cable. Thanks for all the help and comments guy's! Dave!

Thank you dadsbee! But will that retaining cable reach from one side thru the hook and then to the other side? Or is that why there are a two of them in the package? Thank you, Dave