Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Getting ready to replace the axle seals and wondering if anyone has seen this setup. PO has been working on it and the passenger side has some sort of castle style retainer and the drivers side looks original. looks like some sort t of upgrade but this is my first axle I haver attempted to open...
Thanks, I found an O ring that is close out of an automotive air conditioning compressor repair kit that might seal it. it's got some girth but not tight enough you have to roll it on. I'm on the home stretch restoring an old Coronet, the gear box was leaking from all over. The first pic is the...
Hey, I am having the same leak you had, I called Stuart in Ontario and couldn't get a solution. there is a seal in there but mine is deteriorated and I purchased a gates and Edelman kit and those kits do not have that seal. My parts manual says the adjusting shaft seal is part number 1822203...
Selling a 1957 Plymouth dual quad 318 poly small block intake manifold and original set of 1957 1958 WCFB Carter 4 barrel carbs. The carbs are LOCKED UP, they will need rebuilt or used as cores. The Airhorns are both marked 6-1310, the front carb is stamped 1306 and rear stamped 1307. One of the...
Selling a 1964 rear bumper for a Plymouth Fury. I bought this at Carlisle about 3 or 4 years ago never used it. The seller told me it was a early take off of a wrecked Fury but I am not sure if that is true. It could be a restored bumper or a reman I am not sure to tell you the truth. I paid...
Selling a rust free drivers side rear frame rail. It’s rust free, it has a dent where someone bottomed out it appears. It’s straight and the dent could be pounded out. Got this rail from Montana several years ago and sold my project as a lost cause. 350 plus shipping or local pickup zip 22601...
Selling a nice clean rust free torsion bar cross member I purchased several years ago from an Arizona donor car. I sold my old Fury Project the frame was too far gone. This should fit 1962 1963 and 1964 Polara, Savoy and Belvedere as well. If you need measurements PM me. $500 plus shipping...
selling a nice lower radiator support with lower front frame rails attached. 150.00. I also have a nice upper support I can include for 250.00 I will add pics of the upper later.
Selling a nice rust free Torsion bar cross member. Had this sent out from Arizona a couple years ago for my Fury and never used it. It might fit other years, possible 62 - 65 but not sure. I can measure if interested. 300.00
looking for a good set of rear bumper supports. These are the support braces that are welded to the rear frame rails. The piece of sheet metal that is welded to the lower trunk is rotted. If anyone has that piece for sale let me know.
AWESOME!! Thanks allot everyone for the advice, I love this FBBO site and all the support. going to check EBay right now! I been cataloging pictures of my 67 restoration I will do the same with this Torqueflight sub project.
Thanks a lot for the replys much appriciated!! One more question, is replacing a band difficult. I am restoring a 67 Coronet and trying to get this Fury on the road at the same time.