Search results for query: *

I was wondering if anyone has installed modern bench seat from a challenger or charger in old muscle car and how easy it is or what the best way to install and is it better to keep stock side panels or just install ones from modern car. I’m thinking of installing bucket modern seats from charger...

I was wondering if I could buy a 73-74 mounting kit for steering column and it all bolts will interchange with 71. I think the only difference might be firewall gaskets which I already have new.

Thanks I found it!

I am trying to figure out what the part is called and if anyone sells them new. 1971 Plymouth roadrunner. The part is about the instrument cluster and attached to the dash. It is black trim bezel piece. Mine is cracked.

Awesome thanks so much for the information. I will buy a set and do as you suggested. Thanks a lot

How did the summit headers fit? Did you have to bash them at all? Do you have a 440 and/ Do you have the summit headers on a 72 satellite with 440 and/or power steering box? If so how did they fit? Did you have to bash them at all?

I have a 72 Plymouth satellite that has moser 8 3/4 rear end. The pinion angle in rear looks like 6 degrees up and front transmission angle is like .5 down. I’m wondering what angles I need? The rear is up little more bc I moved the front hanger up an inch from leaf spring. The front is low bc I...

I stripped most of my engine bay in a 71 Plymouth but can see micro rust and some paint is hard to get off. So what I was think is to use Jasco paint remover then use Klean concrete and metal prep then epoxy primer? Do I need to neutralize the paint remover with just water and can the metal prep...

I checked float level and it was right height. But possible fuel pressure bc it’s a mechanical fuel pump straight into carb.

It’s about 10 btdc with vacuum advance unplugged and blocked off.

Went to break it in which It got up to 3500 and it was sounding bad so I opened valve covers and two rods were off bc I forgot to adjust them from when I bought it. I opened it up and a lifter had come apart. So I bought complete new set of lifters and installed them. It fired right up and...

Rebuilt 440 mild cam New carb which I have been adjusting. Fresh fuel Hei electric distributor

I start engine and I go to gas it and it won’t go above about 1200. Also shoots fuel up out the top of carb after it shut off. I have a 1411 electric choke 750 edelbrock carb. Could it be the high idle is set to low or too much fuel? I have it on the middle hole and it has better response but...

Yeah it could be, but I will take covers off and check it out. This is my first and anything will help bc I don’t want to hurt this motor or my wife won’t be happy haha.

Here’s the link of the noise. https://youtube.com/shorts/0i77_WVWrWs?feature=share

Rebuilt 440 that I just replaced lifter bc the first set had one come apart after I started it up and the lifters weren’t setup properly. So now new ones are in and it’s set properly in my opinion and I started it up to break it in and heard what sounds like a lifter on driver side hasn’t...

Okay cool. Thanks so much.

Where do I weld in the sway bar tabs to a lower control arm that didn’t have a sway bar? Bought them off summit .

I have a 72 satellite with a 440 with new super stock springs that I’m putting a 8.75 3.55 gears in an idk what the correct pinion angle I should have my pinion and perches?