Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I would like to run a wider tire on the back of my 69RR. I have always like things to match. On the front would be P225/70R14 and on the back would be P295/50R15. I have them on road wheels and would have to buy a set of 15's road wheels. Does any one do this !! Any issues??
Thanks Tom RR
I need to extend my fan on my 69RR 440 HP closer to the radiator.it is into the shroud by only very little. needs to be at least 1/2 way into shroud from what I have been told My current fan clutch is a 070. does it make sense to add a spacer, I would have to use studs to do this, or should I...
I ordered a new Fuel Sending Unit for my 69 RR and by my mistake ordered a 3/8 inch ,but need a 5/16 inch. I can make a good rubber fuel line connection from the 3/8 sending unit to the 5/16 fuel line. Is there and issue doing this ?? I like the new sending unit 3/8, It has a longer Pickup...
The Tank on my 69RR is about 8 years old and I will be pulling it off. How is the best way to be sure inside is Clean ? I will be putting in my rebuilt 440 and want to be sure of the Tank.
Thanks Tom C.
I have two fan clutches one is a AC and the other 070 NON AC. As you can see the AC has a longer shaft and would put the fan in to the shroud where it should be. The 070 putts the fan slightly into the shroud. The is a non ac car and do not care if one is right or wrong. as long as it works for...
I will be putting my 440 back in soon, and was wondering if there any tips out there to install will 6BBL still on motor. Next if I take 6BBL off just leaving the valley pan in place can I reuse it, and just replace top and bottom gasket
Thanks Tom C.
At the moment I am using the stock windage tray in my 440. The engine is apart at this time.
Is there a better option ( Type of tray) Out there. just trying to make some small improvements
Thanks Tom C.
I have the motor out of my 69RR and at this time would like to replace clutch, pressure plate and throw out bearing. I currently using a 12 inch McLeod set up and seem to be working well. I have a few miles on this clutch and seems to be fine , But feel that seeing that motor is out might as...
I was out for drive the other night with my 69RR and had the headlights on low beam and it seemed like every other car coming at me flashed his headlights as though
I had my high beams on. My car has a current Mass State inspection sticker and they do check the head light adjustment and it was...
I will be installing my 6BBL on to my 69 RR 440 . Will be installing new valley pan and was wondering if I should use a Valley Pan with open or closed heat cross overs ?
Thanks Tom C.
I change my clamps from the band style to the wire type, No issues so far , but I do not have the confidence that I had with the band type . Was just wondering if and one puts a sealant of ant kind such as shellac or other type to insure a good seal .
Thanks Tom C.
OK, Has any one dealt with ESPO SPRINGS 'N THINGS ?? I am interested in a new pair of leaf springs for my 69RR and they have a good deal on them. I have talked to Laura The Owner but was wondering if any one had any experience using them???
Thanks Tom C.