Search results for query: *

Hi All. I have a 68 Bee. I want to allow fresh air into the engine. I am looking to cut the blacked out parts on the Hockey Stick hood ornaments and some of the hood material under the hockey stick. I am looking to use the center section of the N96 setup in order to get a seal to the oval air...

Hi yall. I'm getting ready to apply the Superbee stripe to my 68 Bee. I have not been able to find any good documents as to where the stripe is placed exactly. Can someone please provide measurements to this drawing for the tailpanel bee. Also need some measurements for the quarter panel Bee...

Hi all. I have a 68 coronet with the standard steering wheel. Will the wood grain steering wheel bolt right in or would I need other parts? Thanks.

Hi All. I'm restoring a 68 SuperBee. Getting ready to paint the drive shaft except I am not sure what color it was from the factory. It also has an 8.75 rear end. What color was the axle and pumpkin drop-out? Thanks.

Hi all. I am having trouble finding a formed upper radiator hose for my 68 Coronet. 383/4speed. Napa has 2 options and neither fit. Did 68 have a formed hose or did they use a flex hose for the upper? I found a formed hose for the lower. Thanks.

Hi All. What is the difference between AC vs Non-AC fan clutch? I also noticed "Centrifugal" vs "Thermostatic". Thanks for your input!

Hi all. I have a question about my power steering pump belt and pulleys. The belt fits perfectly on the crank pulley but is a little big on the power steering pump pulley. Do I have the wrong pump? Its a Saginaw with the oval neck. Maybe someone swapped it back in the day and it worked ok? The...

Hi All. I found this diagram in the service manual. I cant find a rubber kit that comes with the sleeves. Can i buy them separately? Do I need the sleeve? I thought the Moog kit would come but it does not.

Hi all. After replacing tie rods, pitman arm and idler arm the torsion bar rubs against the tie rod and idler arm on passenger side. I had to remove the grease fitting from inner tie rod on passenger side in order to be able to turn left otherwise it would have busted off. Any ideas on what to...

Hi All. Im restoring a 68 Super Bee. I am trying to get it all back together. The body plug kit came with plastic and rubber plugs. I dont remember where they go. Can someone please help with the location of the plugs. Thanks.