Search results for query: *

I have a square back alternator that has one field grounded to work with the 1969 setup. How much continuity should there be between the two fields when measured at the slip rings with the brushes removed? The only spec I could find was 5-7 ohms and I'm at 1.7. Before I go replacing it I wanted...

William O'Connell Dies: Memorable ‘Star Trek' Villain, Foils In Clint Eastwood Films Was 94 RIP

The oil pan took a hit recently and since I was going to be down there, I did the Borgeson steering swap too. Thanks to everyone who came before and shared their experience actually doing it. It all went as expected with no big surprises. One thing I found was that the upper left bolt for the...

Hello, looking for a woodgrain steering wheel for a '69 charger, driver quality is fine as long as it's all there, thanks

Hello, I'm looking for the plastic piece that goes between this panel and the dash, all that was left of it were the broken studs, thanks

I'm looking for this quarter window roller, I'd buy the set but I only need the one. Thanks in advance

Hello, I'm looking for a roller channel for the passenger side quarter window. Here's a couple pics of the drivers side one, they might be the same I'm not sure. Thanks

Hello, just checking if anybody here has the dipstick and tube laying around before I go and buy a new one, thank you.

Hello, does anybody have the torque or stretch specs for sps rod bolts for stock 440 rods? The best thing I could find was some old Mr Gasket instructions but there was more than one spec for 3/8 bolts and the part numbers given don't exist anywhere. Thanks.

Hello all, I have a 440 I'm putting back together and looking to replace the oil pump drive shaft, it already has a new bushing installed and sized. Does anybody have any insight as to which of the available shafts to stay away from if any? The prices are all over the place, milodon $141, Mopar...