Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Hi, Once again i am back asking for some help. I finished up the convertible only to find out the back up lights do not come on.. I went to the switch (lower part of the column) only to find out the lever to engage the switch is missing (gone, gone). Does anyone know where i can obtain one...
All,
Thank you for your advice and HELP!!
I have seen several threads but not a recent one on electric fuel pumps and where to mount one on a 1967 Coronet 440. Here are some specifics:
I have replaced the gas tank, float (3/8" outlet) , fuel line (stainless, 3/8"), fuel pump ( 3 times (now...
I am finishing up my drive train ('57 coronet) and i want to install a voltmeter while keeping the ammeter. i just want to verify that all i need to do is plug into an ignition (on) wire after the fuse block and perhaps wire in a 1 amp fuse. Plus, a good ground. Correct?
thx in advance
All,
thanks for your help in advance.!!
i am trying to figure out if my 1967 440 convertible (with RB 440) should have a 3 piece kick down linkage or the single rod. It has never kick down properly and with the single rod, i am having issue adjusting,... The rod is too short to throw the...
ok.. i now have my moter... 512 cu in..505 hp with 605 ft. lbs for torque.. I spoke to Lenny at Ultimate and he said i need to find an 11" hemi, non lock up, wide gear torque converter. he will rebuild it to match the weight of the car, engine, rear end, etc.. Does anyone know where to look...
All,
Thanks for your responses in advance. I am swapping out the stock intake and carter carb on the 440 for an Edelbrock performer and a quick fuel carb.
Question is,.will the hood close with the stock air cleaner (dual snorkel) with no clearance issue?
thx!
Apologies for this question if the forum has covered it many times. I have '67 coronet 512 cu in., with a 26" aftermarket radiator (2 row- 1.5" tubes) and will utilize the '70''73 b and c shroud. This shroud has the 20.25" opening and 4 bolts hold it on the radiator. Has anyone run the pn...
I need a good set of 2.94 gears and pinion and a sure grip for a 742 case. i have the pig/3rd member. Plus, does anyone know if 2.94 gears are still be manufactured by a 3rd party? thx!
I am trying to find out if a 1966 Plymouth Fury III (383-4 and 4 speed) would have come with a 742 or 489 third member case, 3.23 gearing and sure grip? Would that have been standard with the 4 speed? Thank you for your input/responses!