Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a 73 charger with a 440 with the higher 78 amp alternator it had issues charging before so I put a new regulator in the car and it fixed my charging issue. However it still has an issue where the radio will cut out when I apply the turn signals and brake lights at a stop sign. It's an...
I've got a 73 charger that I swapped a big block into it has a new battery and a new alternator.
My problem is it wasn't charging before and I figured the factory gauge just didn't work but it died while driving a few times. I've played with the box on my firewall and then it started bouncing...
I have a fresh built 440, it has an aluminum water pump and housing with an aluminum Radiator. The cap is a stant 10230 16# it has an engine fan and auxiliary electric fans that come on at 220. It seems like the water sprays out of the rad cap starting around 195 until it hits higher and starts...
I've got a low compression 426 wedge fully rebuilt. It has about 80 psi or more at idle when cold and goes to about 40-50 while driving hot I use 10-w30. Is this a safe average or should I use a bit heavier oil.
I'm trying to start my engine in my charger its a 440 low compression with an msd-like ready to run distributor. it cranked for a while and we had to pull the distributor and turn the gear one over because it was off and then it actually starts. The issue at hand now though is it dies as soon as...
My dad's superbee has an issue where it's not moving in reverse even at higher rpms but if you build pressure in neutral it'll move for a few seconds before needing repeating. It seems to work okay when it's warmed up. It's been sitting for a year with infrequent driving before this.
Did mopar change casting numbers for intakes after 74 because I can't find a list that goes past 74, I've got a 77 400 I want to do properly coded and numbered but I don't have the intake.
3698442 is the last number I can find.
I have purchased new polyurethane bushings for my upper and lower control arms but I'm unsure how to change them. The uppers I'm not sure how to remove the shaft the goes through the bushings to press them out and it looks like there might be a weld on one of the bushings as well. The lowers are...
I'm planning to put an 8 3/4 rear in a 73 charger I have the earlier spring mount to eliminate the one bushing but I want to know what part of the front hanger makes the bushing change to oval bushings. I assume it's the hole in the spring itself and if I want to use the 6 leaf springs from a 74...
I'm trying to see if they ever made a piston for my application or if I need something custom or modified.
. 30 over
1.094 floating rod
Forged
At least 10:1
https://www.summitracing.com/parts/esp-6358c3d/
Those are the rods I have to use, I'm in southwestern Ontario so the used market isn't as...
I'm planning a build for a high rpm 383 with a tunnel ram in a car that's less than 3000 pounds. I want to build an 8000 rpm low deck for somewhat cheap.
I've got a 66 383, I'm planning to get some aluminum heads from a swap meet and looking at about 4.56 gears with an automatic around 4000...