Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
Doing research on swapping a Hellcat into a 1967 Belvedere. I want to use stock hood, anyone know if that will work? Open to different front suspensions to use stock hood.
I would like to get these parts out of my shop. I do not want to scrap!!! I tore down a 440 for a stroker project and have almost everything that I took off that block. Motor appeared to have extremely low miles. The motor was sourced from a 1976 RV.
Heads
Exhaust manifolds
Cam
Starter
Timing...
Going to swap the gear out of my 8 3/4. it will be my first time. The rear end has very few miles on it and works perfectly.
Could someone humor me with a parts list that I will need.
Thanks
Ok so I built my first motor, for my 1967 GTX. 440 based 512 with an RPM Performer intake with Atomic throttle body. Of all things that I can't seem to solve is getting the air cleaner to fit under the hood. I want to use the original dual snorkel cleaner. I have tried virtually every drop base...
440 source fabricated valve covers and MSD distributor. I have ground the valve cover flange as far as I think I can. I can now install the distributor but it has very little room. I can install the cap and rotate the distributor but the spark plug wire ends contact the valve cover. Should I be...
I've always wanted to build my own engine. I am planning a 440 based stroker. I have located a running 440 out of a motor home. The casting date is 1976. I am planning on updating this thread as I make progress in the hopes that you guys will jump in if you see a rookie mistake!! I did start to...
I have a 67 GTX with a 440. About two years ago I installed an Atomic EFI throttle body. Intank pump is a PA series from Tanks Inc. and the pressure regulator is from Aeromotive. I recently noticed that the fuel pressure was a little lower than it had been. It is running at about 38lbs. and was...
Hey everybody!!
I was a somewhat active member a few years ago but have only been creeping for awhile now. I own a 1967 GTX and a 1972 Scamp. I have finally pulled the cover off the GTX to get somethings done that are far over due. Looking forward to being active again.
Green72