Search results for query: *

Grandson's were excited to go with Paw Paw to pick up his new project car !! 67 Coronet 440 . Now a 2010 swapped 5.7 HEMI

Looking for a automatic console top plate for 66-68 b body

looking to buy a set of 67 Coronet 500 , R/T front bucket seat covers . legendary orders are out till July 2023 . I need a set sooner than that . Anybody holding a set they want to let go of ???

in need of the screws and plastic bushings for the wood grain steering wheel horn switch . three screws and three bushings .it is not the so called Recall wheel . Thanks

Can anybody recommend a reputable transmission builder in NC ??

I am looking for a small block 727 w/torque convertor ready to install. I need it for a 67 Coronet . I need it to be somewhere in North Carolina if possible

anyone do a 6.4 based 426? if so enlighten me on parts and process please .

Anyone going to Rockingham this week end? anybody going that has any 66-67 Coronet possibly RT stuff for sale? Or possibly 66-67 Plymouth Satellite stuff?

anybody local to NC have a good hood for a 1967 coronet ? possible deliver to rockingham ?

ok so the 67 Dodge and Plymouth b body's have a 1 inch diffrence in wheel base lenyht. so where is this one inch difference ? floor? rear springs?

ok , so my 67 coronet R?T has a build date of 9/28 . i am assuming that is 9/28/66 ?

looking for a good 67 dodge coronet hood preferably in NC . no rust or bent up hoods please

i need a decent front bumper and brackets for a 1967 dodge coronet . in or close to north carolina would be great ! Thanks!!

Looking for just the rear section ,maybe 6 inch piece of the trunk extension for a 67 Plymouth/ Dodge . For drivers/ left side. If anyone has this section I would like to buy it . Or a whole one since I am replacing trunk floor

Looking for a good rear drivers side over the wheel molding pieces un damaged or not bent. really looking for a nice driver quality piece Thanks

Looking for my next project . 67 coronet post or hardtop .Prefer floor shift car .auto or manual . light project (really not looking to replacing alot of sheet metal) . Needing some panel replacement is no biggie but not a complete amd catalogue that is out of the question. Since my current...

A while back I saw a post where a guy used modern lx rear brakes and machined the brackets to fit a 8 3/4. Can't for the life of me find it now. Was that anyone? Do you know the poster? Have it saved ? I really would like to find the tread again. Thanks !! Update: found it !! it's under B...

Anyone in NC have a 46 RH trans for sale. Need one for a GEN3 hemi swap in a 67 satellite

bought a new mopar performance six pak cam.. the finish don't look right to me. kinda dull non machined kinda look . anybody got any imput on this new finish? looks almost cast color as in a dull greyish finish.

for sale is a new never ran Mopar Performance purple shaft .509 cam for a big block .was installed and never ran .located in central NC .$350 shipped in USA