Search results for query: *

1969 coronet 500 convertible, standard dash. No dash lights. Pulled the switch panel plate out (that's another story) and have the dimmer switch out. Is there a bench test to determine if the dimmer switch is operative ? I've got full voltage at the top terminal connecter (14.5 v, that is...

what is the correct installation depth of the rear bearing on a roundback alternator ? Should it sit flush to the rear case ? Pic 1 is current alternator where bearing sticks out about 3/32 from rear case Pic 2 shows inside of rear case where bearing is flush to inner case Pic 3 is previous...

Is it OK to helicoil a stripped pulley hole on the harmonic balancer or is there too much rotation and stress on the pulley ? Stock 1969 3018 that doesn't see high rpm's.

When the brakes are applied, the brake light bulbs and all turn signal bulbs light up. When the brakes are applied and the turn signal is activated, the brake bulbs light up, all the turn signal bulbs light up, and the selected left or right turn signal bulbs flash. When the flashers are...

1969 Coronet 500 convertible. The 2 convertible top latches that I have are in good shape. I need the 4 pins that hold the latch to the housing in the header panel. The pins are ribbed about half way and the pin measures about .194 in diameter around the ribs. The non ribbed diameter...

1968 coronet lower grille panel. very nice condition, no rework needed. Painted A4 silver metallic in 2007. Car has been under wraps in garage until restoration was restarted this summer and discovered this 68 lower grille panel was on the 69 coronet. I found a 69 panel at Carlisle so this...

While disconnecting the headlight harness connection from the sealed beam, I created an arc and now the headlights do not come on. I previously read that the headlight switch contained a circuit breaker . Is there a breaker that can be reset in/on the switch ? The manual says to remove the...