Search results for query: *

Hi everyone, upgraded my fuel system today to remove a home made fuel rail on my 67 coronet with a 440 with 870 Holly Street Avenger. Here’s what I upgraded Installed new Carter Fuel Pump M6903 Installed new Comp Cams push rod with chromoly tip, mine was measuring at 3.05”. Upsized fuel line...

Been messing around with coils in my car, got a MSD high vibration (can be mounted horizontal) and this thing gets smoking hot after 5 min of idling. Engine starts spurting and then does. The. Takes a quite a few cranks to fire back up. Is this normal? I did jump the ballast resistor. 67 cornet...

What’s with these inappropriate ads on this site. Wtf…my kid goes on here. Can you guys put appropriate ads on your site.

Looking for the 2 odometer gears that go behind the speedo for 1967 coronet. I’m sure other years/makes will work. Or does anyone know where I can purchase them? thanks J

Hello, thinking about swapping out my Holley Street Avenger 870cfm, think the carb is a little to big for my motor set up. Car is for cruising but like to take it down the track a couple times a year. Any recommendations on the carbs below? Car/Motor specs below AVS2 800CFM Slayer Quick Fuel...

Going to upgrade my ignition system, thoughts on the 3 systems below? Currently have electronic ignition with Mopar ECU and MSD high vibration coil. MSD-6AL with MSD high vibration coil Rev-n-nator with their coil http://thertgarage.com/products.html FBO with their coil...

Thinking I have some sort of ignition issue with my 67 coronet. Went for a drive yesterday evening and about after 10 minutes the car died while coming to a stop. Cranked it and it came back to life and drove another 300 yards and it died and wouldn’t start again. After 5 min cranked it and it...

Got a 67 coronet with a 440 and a Holley 870 street avenger carb. Car has a hard time starting, need to rev and hold it at 1200 rpm to warm up a little so it will idle on its own and has a ruff start till it’s been warmed up for a min or so. I’m thinking my elec. choke is not working properly...

Looking for help/advice on a shifting issue 1967 Coronet convertible Mild built 440 727 trans 8 3/4” rear with 3.23 When I step on the gas and don’t let off, when the car shifts to 3 gear the motor just bogs down like it died. I let off the gas and lightly step on it and the car still has...

interesting situation... 1967 Coronet with power disc brakes up front and drums in the rear. 440 with a cam, previous owner added external vacuum pump for the power brakes. Everything was working fine on a drive this past weekend and pulled into a parking lot and the car useless for about 5...

Just picked up this 1967 Coronet RT Clone with 440

hello Just purchased a 1967 Coronet Conv and the windows need some work as they are difficult to roll up or down. Looking for a some sort of repair write up on replacing all the rollers/etc... that someone has published, if anyone knows of any please post a link. If there isn’t, I was thinking...