Search results for query: *

Not concerned about factory look....other that I want to maintain the factory height ......Thank you!

Who makes the best manual front disc brake conversion kit for a 1966 Satellite with 14 inch wheels?

Who makes the best manual front disc brake conversion kit for a 66 Satellite with 14 inch wheels

Say Dave here’s two shots of fan and shroud.

Thank You Sir.Ed

Thanks for the info TN mopar.Ed

Thanks again for the help Khryslerkid.Ed

Thank you Khryslerkid for the good Info! Ed

Thanks Dave,I will take some photos tomorrow and send to you tomorrow.I like the guns and parachutes. I live in Pennsylvania and we are in the sights of the anti gunners. Ed

Thanks for your input.Im using a 1966 426Hemi shroud on a 26 champion aluminum Rad.Prestone 50%?No not boiling over or pushing out.Its gone up to 210 degrees at that point I raised idle speed to bring temp back down. Ed

I used DynaMat Xtreme .067 sound dreading only so far.Was thinking of possibly adding 1/4 inch. Of Dynamat Control DynaLiner for insulating and additional sound deadening. Before installing legendary carpet with some Jude backing.

Thank you for your experience. Nice photo patriot! My engine puts out some heat. I purchased 69 HP 383 block it had rust in it. I thought I did a good job of getting all the rust out of cooling passages.Engine runs great lots of power. If it sits and Idols at eight 900 RPMs it’ll get hot...

Thanks for input Ed

Just finished covering every square inch of interior, floor,sides and ceiling with DynaMat Xtreme sound deadener.Wanted to quiet exhaust noise and reduce engine and exhaust heat in my 66 B Body 426 stroker.l put 1/4 inch DynaMat Liner in ceiling but thought may be overkill on floor. Would...

Thanks Erickson appreciate your help.Ed

Doug thank you for your help.Ed

Thank You INTMD8. I’m no machinist either. This is my first rodeo building a engine.I’m going to try to connect with the machinist again tomorrow.and go over this again with him. Thanks again for bringing that up.Ed

Thank You Sir.Ed

Thanks Jeremiah.Good point!I bore lined and squared my bell housing to the block after I built the engined.Ed