Search results for query: *

Selling wheel covers that are in good, driver condition. I will only charge the actual shipping cost to buyer (USPS) after purchase. Time to clean out stored parts. My zip is 20685 $40.00 + actual shipping cost to your zip code I only ship to the lower 48 states I accept PayPal or...

Alternator has been refurbished but I never used it. It is very clean, looks brand new. Single pulley but not sure of what amperage it was rebuilt too (37-46-60). Local auto parts stores only test internally regulated alternators. My zip is 20685 and I will only charge actually USPS charges...

Selling 4, OEM, used 65 Belvedere wheel covers that are in very good shape. These were on a driver I had. They are OEM, 14" covers. The center emblems have some very fine spider cracking in the plastic, faded red/white/blue emblem paint and has to be viewed up close to be seen. A few nicks but...

Selling a used, OEM radiator shield, part #2445784 that fits a 1965 Belvedere/Coronet. This is the shield between the bumper and the lower radiator support. It is in excellent condition, not bent up etc. I only ship to the lower 48 states. I accept PayPal, check/MO. I ship after the...

This is the gear indicator lens (part #2530242) and retainer (part #2530243). Both are oem, used parts. I removed these from a Belvedere column shift automatic steering housing. Both pieces are in very good condition, are easily read and include the screws that mount them to the steering...

This is OEM, used part, part number 2822170. I removed it from a 1965 steering column and it is in excellent condition, no broken or missing wire ends installed at the factory. The orange light bulb wire however is missing the connector end and bulb. This was always a separate wire, not pat of...

The overall condition is good. The circuit boards look good as does the speedo threaded connection. The flaws...shows fading from age, not shiny like when new. The speedometer numbers are yellowed and the 1/10 wheel is crumbled. Not sure the speedo needle or other gauges/needles function as they...

I put a 3" TTI exhaust kit/headers on my Belvedere and did not use four (4) of the 3" clamps (with bolts and flanged nuts) and the one (1) hanger bracket (with 4 bolts, lock washers and nuts) on my install. These are new, never bolted on, used for mock up etc. I only ship to the lower 48 states...

Just needs some TLC. One end has small chunk missing from chrome on one end as shown in picture with the courtesy light and toggle switch (I never tested this electrically to see if circuit is good). Slight pitting on parts of the chrome on each end of trim as shown in pictures. The ashtray with...

Selling an OEM, very rare, '63 Sport Fury used console, complete with the major componemts, missing the carpeted sides. It may have been used in other models? It is in fair condition with original mounting brackets/feet and has the under console wiring and connector. It has a lock but doesn't...

Selling an OEM, rare pr. of 1965 Coronet 500 bucket seats with trim pcs and floor mounting brackets. Someone attempted to spray dye the covers, botched the job. These would need to be recovered but the seat frames are rust free as are the seat adjusters which operate like they should, no damage...

Used, OEM, dashboard ashtray for '64-65 Belvedere/Satellite. In very good condition. I only ship to the lower 48 states. I accept PayPal and check/MO. I ship when check/MO clears my bank. $50.00 includes shipping

Selling a new, reproduced '60-'65 speedo pinion seal, o-ring kit and the OEM, used, speedo retainer for the 727 case. I bought the seal/o-ring (still in sealed package) new. The seals come with instructions for installing. Will not fit '66 up transmissions. $20.00 includes shipping I only ship...

Removed from a 1965 big block 727 torqueflight car I owned. The OEM cable is in very good condition, inner cable spins freely using my fingers and threaded connection is not stripped/damaged. It has a 19 tooth gear also in excellent condition. There is one blemish on the cable sheath from...

I have a factory original 1964-1965 console shell configured for an automatic (the 4 speed hump can be attached). I have not removed/cleaned the glue residue that held the carpet onto the side of the console. The console was dropped and has slight corner damage on one corner (all there but...

This is an OEM bench seat adjuster release cable. It measures approx. 44 1/2" from the end of an eye to the other end of the eye. Never used or installed. Please measure your need before buying. $25.00 includes postage I only ship to the lower 48 states I have PayPal account and accept...

Selling ONE (1) 62-64 bench seat hinge cover (one on eBay had the same serial number as this one) and the metal clip that attaches it to actual metal hinge. The serial number is 2522407. It is in fair-good condition, not cracked, holes not wallowed out etc. It does have a few slight wear/rub...

I removed, cleaned and painted these OEM bolts, nuts and washers that were originally on a few 65 Belvedere's I owned over the years. 15 of the bolts have a raised letter "H" on them. These are course and fine thread bolts/nuts. I hate to use these for odd ball uses. Approx. 70 bolts...

Used 1965 blower assembly. Blower works as it should, missing the end on the ground wire (it was cut off, easily replaced). Coloration is how they usually appear even though never wet, damp etc.. Rubber sealing ring attached as it came from the factory. I only ship to the lower 48 states...

Removed from a 1965 Belvedere. OEM, used cable which controlled the factory heater temperature using the vertical slide lever next to the push buttons used for selecting mode you wanted to use. The green ends came off another broken cable, they were split and supper glued onto this cable which...