Search results for query: *

I am pretty clear on most items on my fender tag. I am trying to find out if my car is a California Emissions (CAP) or 49 State car. Thanks for any help .

I have a 1970 dodge superbee. 383, Manual Trans, no Air, has PS and PB. I am trying to determine the correct carburetor to install. I do not know how to identify the letters on the left column above. The build sheet says 36. Thanks

I am trying to determine the correct size FACTORY rally wheel for my 1970 superbee. The code on the build sheet is unreadable due to the spring rusting. Is it a 14 x7? Thanks

I have read a bunch of articles on what is the correct power steering fluid is for the car. The book calls for correct power steering fluid #2084329. So what should i use?

Anyone know what size screws hold in the 1970 dodge Quarter Door Jamb Seals which are below the quarter window? I had 4 different kinds of screws and would like to have them all the same. Thanks

SEAT TRACK MOUNTING NUTS/BOLT NEEDED I need one nut/washer that holds the seat bolts under the car 1" diameter washer, 5/16" x 18 thread 1/2" head on nut I know i can buy them new. But figure if someone has one i prefer to buy from here before i buy on line. I know these fit a lot of years

How does it come out. Not from the front. I read that you can unscrew the dash mounting bolt behind the pass side kick panel, but that did not give me enough room out the back. Any help please? Ultimate goal is to replace the dash pad.

I have a 70 superbee. Rear window is installed. The rear package tray was gone when i got it. The windlace, or inner trim that goes around the sides and top of the rear window was on the back seat. It is a one piece unit. I see how the package tray and rear trim rubber go in, but i think i...

I need to replace my dash pad. I see two different prices on ebay for pads. Anyone have ant experience with dash pad purchases? I do not want a cover. Want it to look original. Thanks

1970 coronet superbee. I have been looking for quite a bit for the correct plug for the inside of the car door. Its a small plug. the hole is about 1/8" diameter. I have one on the pass side but need one for the driver side. it is right behind the remote mirror handle. Anyone know where to...

I have a 70 coronet. The seal at the rear of the hood was missing. I found one in a junkyard with rusted off clips. I found the clips on line. From the indents on the rubber, I can see how they are installed on the rubber. I am not sure how it goes on the car, meaning which direction. I...

I have a 70 coronet. 383 4 speed. headers. I have owned the car for 13 years. Drive it in the summers. I took it out last week for a 50 mile ride. Perfect. Yesterday I started it in my garage and I started it and heard a big backfire. I restarted it, it ran rough for a bit and then it...

I had to move my 70 superbee today. Its 5 degrees out. I had the car running a good 15 minutes at idle. No heat. I checked the supply and return hoses to and from the heater core, One was cold the other was hot. Not extremely hot though. I also noticed that the temperature guage did not...

Tonight I took out my 1970 superbee. It was dark so I turned on the lights. Everything worked perfect. I stopped at the grocery store and accidently left on the lights. I was in 10 minutes max. I came out and the lights were on, but not enough power to start the car. I got a jump start and...

I need one or two Goodyear Eagle ST 15" tires. I have two good ones and have two that are bad from PO not getting an alignment. Anyone have them laying around?

I have a 70 Coronet Superbee. I have the broadcast sheet for the car. I am second owner. I am trying to get the correct wheels. The broadcast sheet has a rusted spring line right through the wheels section. What I can make out is this from right to left. Right Spare 16 Middle Color...

Can anyone send me a picture of a correct style radio for this car. Is it the one where the dials roll up and down? Also, what is the going rate to have them rebuilt if I find an old one?

I have a tru 70 bee. I am the second owner. The first owner, I believe, replaced the nose 30 years ago. I have repaired the grills as they were missing some pieces. Now its time to paint. I obtained two doner grills in the process of repairing the grills. In doing so, I came to realize...