Search results for query: *

LCA's with sway bar brackets are worth $75 - $100.

Probably. I had the same carb listed for $125 and no bites.

This is an NOS Carter Thermo-quad carburetor 6139 SA found on 1972 340/AT. $625 Located in 19464

From the tti site: 3-4. HEADER-BACK EXHAUST SYSTEMS (Headers sold separately) Header-back exhaust systems include • Mid-Section Assembly (H-pipe or X-pipe design) • Dynomax Super Turbo Mufflers (Available with or without) • Muffler Hangers • Over-Axle Tailpipes • Tailpipe Hanger...

Up for grabs is a 68-70 B body tti exhaust system I bought a while back for a project that did not come to fruition. It's a header back, 2 1/2" X pipe system , new in the box - only opened up for the pictures. Part# XB25HW6870 $625 located in 19464

From the tti site: 3-4. HEADER-BACK EXHAUST SYSTEMS (Headers sold separately) Header-back exhaust systems include • Mid-Section Assembly (H-pipe or X-pipe design) • Dynomax Super Turbo Mufflers (Available with or without) • Muffler Hangers • Over-Axle Tailpipes • Tailpipe Hanger...

Up for grabs is a 68-70 B body tti exhaust system I bought a while back for a project that did not come to fruition. It's a header back, 2 1/2" X pipe system , new in the box - only opened up for the pictures. Part# XB25HW6870 $625 located in 19464

This is an NOS Carter Thermo-quad carburetor 6139 SA found on 1972 340/AT. $750 Located in 19464

This is 1968 440 HP2 block that has been cooked, magged, square decked, had 3 sleeves installed and rough bored .030 over. There is a small amount of flash rust from storage, but not in the bores. The vin # is 8G166970 which would indicate a St Louis built car ( GTX, Coronet R/T or Charger...

*bump*

Headers back, any v-8 3-4. HEADER-BACK EXHAUST SYSTEMS (Headers sold separately) Header-back exhaust systems include • Mid-Section Assembly (H-pipe or X-pipe design) • Dynomax Super Turbo Mufflers (Available with or without) • Muffler Hangers • Over-Axle Tailpipes • Tailpipe...

I could, but I think it would be mighty spendy, unless you go with Fastenal perhaps. It measures 12 x 21 x 63 and weighs in at 98 lb.s

Up for grabs is a tti exhaust system I bought a while back for a project that did not come to fruition. It's a header back, 2 1/2" X pipe system , new in the box - only opened up for the pictures. Part# XB25HW6870 $625 located in 19464...

Here we have a 69/70 Chrysler 8.75 rear differential with a 489 case, housing a 3.23 Sure Grip unit. 7290 U joint and 11" drums - complete. Drum to drum is 60.25" Spring perches are 44" $850 Located in 18041

Any chance you have the VIN # ?

Up for your consideration is a Centerforce II pressure plate for an 11" clutch. This was mounted on an engine in a test stand for mock up, but never run in a car. http://www.centerforce.com/products/product-detail/id/CTF-CFT361800/name/centerforce-ii-clutch-pressure-plate $175 plus the ride.

Can you tell us who made it ?

That would be a St. Louis built GTX.

2bbl or 4bbl ?