Search results for query: *

This is what I'd recommend if they're being used as a backup where your latch is still holding the hood at the correct height. This being in the A12 section... aren't those lift off meaning no latches?

Is it in an area where you could make a support that can be fiberglassed in from underneath that would support It? 1/8 flat stock would likely do it, just prep the underside, place brace where it supports the low spot and glass over it. Adding much filler adds weight to an already weak or low...

I'm at 800 with a stick shift.

I'm running the next cam up from that and have no problems pulling 15" of vacuum however mine would run like crap where you have your timing set.

To my knowledge "No" however they did stamp the Vin on the block and trans, the problem here is they were hand stamped and some slipped threw without getting stamped. The motor stamping (if it's there) will be on the passenger side right above the oil pan rail on a machined surface and the...