• When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.

Search results for query: *

  1. Darrah

    What is this Part?

    As stated above, vacuum reservoir. My '71 A/C car has it as well, although mine is still hooked up. Service manual shows it in the diagrams for vacuum routing for the heater box. Also as an FYI, there's an inlet and outlet (check valve). If you hook it up backwards, you won't have vacuum to...
  2. Darrah

    Summit oil pan

    I just installed one on my hemi. Not the same windage tray you're using, but it worked out just fine.
  3. Darrah

    Valve Spring Recommendation

    Got a chance to pull a spring and get measurements. Accurate to within a few thousandths; only had my cheap calipers available. Height- 2.450" Outer Spring OD- 1.540" Outer Spring ID- 1.130" Inner Spring OD- 1.005 Inner Spring ID- 0.725" Retainer Inner Step- 0.710" Retainer Outer Step- 1.110"...
  4. Darrah

    Valve Spring Recommendation

    I agree, and I've tried to reach out to them for information. Unfortunately like most places these days, they've not gotten back to me. The retainers are Comp Cams 732-16. I don't see anything listed for spring cups. I'll probably remove a spring this weekend to get physical measurements...
  5. Darrah

    Valve Spring Recommendation

    They're MPP heads from back before Edelbrock made them. PN 4529336. Engine builder bought them as a bare head rather than pre-assembled. Looks like they take all factory valvetrain.
  6. Darrah

    Valve Spring Recommendation

    Appreciate the help.
  7. Darrah

    Valve Spring Recommendation

    I'm finally getting my 528 hemi ready for install (hopefully this winter) and have decided to replace the valve springs. The engine has been sitting assembled almost 20 years, so I figure it's cheap insurance. The engine build sheet lists the installed springs as EWK 960-16, which I can't seem...
  8. Darrah

    Hydraulic Throw Out Bearing Problem

    That's normal for the hydraulic bearings in Tremecs. I noticed the same thing putting a T56 in my son's RX7, and turns out that's the way it's designed. Lots of F-bodys out there with lots of miles, so that's good enough for me
  9. Darrah

    Hemi Build Advice

    Glad I asked… I would’ve wasted money on springs as a preventative measure. I was planning on priming it and rolling it over to make sure oil gets to both heads. Any opinion on what type of intermediate shaft to use for the distributor drive? It had a bronze gear but my son accidentally...
  10. Darrah

    Hemi Build Advice

    I've been sitting on a 528 hemi for a few years now (part of a previous project), and it's time to start prepping it for install. The engine was built in 2003 by Hensley Racing, but never installed, fired, etc. It has been sealed and stored in climate control, and I recently cracked it open...
Back
Top